Claimed OU circuit of Rosemary Ainslie

[PaulLowrance]

I don't know how many ways I can ask this. Can you please be specific and clear:

Can you provide a circuit that contains either *all* of the exact part #'s, or the exact method of making such parts? You say you can replicate it, and get success. Why not tell us the *exact* details to accomplish your claim so we can get on with it? I will not and should not start until you can be clear.

After looking at the circuits that claim successes, which so far is only Ainslie's, I do *not* see sufficient information to replicate it. There's to much gray area, and this almost always leads to a lot of wasted time.

Thanks!
Paul

[poynt99]

And I now suspect the claim made in this thread is the same. Notice how Rosie has asked me numerous times to make her device. It's as if these people get compensated for the number of people that replicate the fake.

I'll wait and see poynt99 results before wasting further time on this claim, which I am now over 99% certain is a fake.

Paul

Paul,

Regardless of the outcome of my results (which are on their way), I would not categorize Rose's claims as fake. "Fake" implies intent, and I am 100% certain that this is not and never was Rose's intent.

Her claim of COP>17 is based on measured and calculated results, not on fakery. The most unfortunate part is that none of the results or original test components are available for further 3rd party verification.

So here we stand...

.99

[Rosemary Ainslie]

Paul -  to answer your private message - I have no interest in proving to you whether or not I am who I say I am.  Certainly I will not do a pay pal exchange.  And I think it's a matter of extreme irrelevance as to whether I am female or male. 

And no I cannot answer your previous post beyond what I've already said.  But feel free to keep asking if it helps you at all.  I'm sure the contributors here rather expect this thread to regress rather than otherwise.

[powercat]

Hi Cat.  I know I'm treading on toes when I refer to TK.  He possibly did good with Mylow.  But I'm beginning to suspect that he withdrew from this thread because he had - indeed - seen the gains that he was denying.  And I am NOT MYLOW. 

Frankly I'm not sure that he managed the damage on my claim that he clearly intended.  And - in a strange way - it taught me that the contributors on these forums are actually more discerning than our academia.  None of them picked up on the errors.  So.  It's a tribute to the talents here.  Or to be more precise - a tribute to TK's talents.  But errors are errors.  They are not necessarily attempts at factual distortion.  I hope - by now - my credentials in this regard are accepted.  If not - then they never will be.

I just wish someone would post some music.  This is getting really sad.

Hi Rosie
I don't think anyone should doubts your credentials the circuit is where the problem lies.
As you seem unable to provide anyone with an actual working circuit I think this problem will continue.
We are all hoping that .99 will be successful.
I was going to post "always look on the Bright side of life"  too obvious
so now something comple different
http://www.youtube.com/watch?v=KVOdX8ZzYuU

cat

[fuzzytomcat]

Hi All,

The First testing results on the Rosemary Ainslie COP>17 Heater Circuit http://www.energeticforum.com/67700-post2625.html on the Quantum October 2002 article http://www.feelthevibe.com/free_energy/rosemary_ainslie/transient_energy.pdf using the Tektronix TDS 3054C on loan from the Tektronix Corporation is available.

This test is using store bought "off the shelf items" for these results -
http://www.energeticforum.com/69858-post2878.html

Further testing to follow with my prototype "Borosilicate Glass Tube" ( Pyrex ) 10 Ohm wire wound Quantum "load" resister http://www.energeticforum.com/68032-post2684.html .... and further testing after that ....

Fuzzy   

----------------------------------------------------------------------------------------------

EDIT-

Additional Information on timing of the Mosfet "Source - Drain - 555 timer"

NOTICE THE 220 VOLT SPIKE ON THE MOSFET DRAIN !!!

http://www.energeticforum.com/69850-post2875.html

"Shunt Resistor" Dale RS-2B .25 ohm 3 watt 3 %
http://www.diyparadiso.com/componenten%20passief/dale%20rs5.pdf