Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[Ganzha]

Hello everybody!

I am not selling secrets....just sharing information about our TK replications based on Induction heater+current Amplifier.

I  would very appreciate for any donations meanwile

email  ziart@ya.ru

Here is video of success
http://youtu.be/queWs4EdLWc

PS I  try to show you a colution!
PSS Our replicant I Real! World is not ended after revealig os tk SECRET. NO KGB OR Man in black.....shaisse!

[forest]

Ganzha

I think this is a blind path. We all know that it must work with HF so that part with induction heater is nice showing us the output part which is insignificant. Remark - no ferrite rings (though it may work for some small power as shown by SR913).


The MAIN IDEA is to get this HF of BIG POWER from small insignificant amout of normal electric current like 100W
100W in 5kW out.

I believe ground and spark gap is essential for two things : discharge electrostatic charge and modulation to 50Hz
You all are repeating the same big mistake. Tesla coil, Tesla coil, Tesla coil ! Like the big shout during the soccer match  Think in reverse.

[Collapsingfield]

@Captainkt, great news. I hope you measured or estimated well the input/output powerratio. Reading your previus messages we can see that the steps are not trivial. I think the fine tunning is important as well. The inductions plates are working with different chipsets, and frequencies. We would appriciate any more hints.
Regards
Collapsingfield.

[captainkt]

@Ganzha, its just a hob from ebay 1800 watt single plate, after all it is just a mass produced oscillator, I am getting best results ever after 5 years of blowing up £50  oscillators from Cybernetics, the heater was only £30. It is similar to the one in video but I removed top and put coil between glass and inductor coil then you can put steel plate on top to get rid of auto shut off. The night before I tried this I had difficulty lighting a 60 watt bulb with MOT cap, spark gap, and lots of noise. I am well pleased. Now going to try to get even more out by connecting more coils in series parallel or bifilar. Thanks for pointing me back in this direction I tried induction heater some time back but obviously did not get it right then. Whats really interesting is how when started you can go from 1800 watts down and down with the power and the load remains almost as bright. I could not believe how much load I could put on the end.
Regards
Keith

[captainkt]

@Collapsingfield, I have not really done much in the way of calcs but my workshop runs on a 10 amp trip and with most other circuits using MOT transformers I often blow the trip when experimenting, last night the load heater I was using (1500 watt tube + 1500watt tube total 3kw +400watt bulbs) did not blow the trip, it did however melt a few of the maplins leads and crocodile clips which I had to change for stouter wire. Will work out things better when I get home Wed night.
Regards
Keith