Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[Hoppy]

Dear Dave45.

However they did not last long as the contacts would weld closed !! I recently looked at the latest Akula0083 schematics (not TPU) and he was using the IRF 3205 which if I have read correctly has an 8 milliohm drain to source resistance. Pretty low !! But not as low as a metallic short !!

Cheers Grum.

Afternoon Grum,

But maybe as low or even lower than a metallic contact with oxidisation / burn after a short period of time due to switching?

[verpies]

http://www.youtube.com/watch?v=02SssZ5JOFc
Necessary financial support for the project !!!!

WOW!  That's a huge motor!

Did you build that?
How much time & money did it take to build just the frame and that huge rotor with permanent magnets on those bearings ?

I can see that this motor does not close the magnetic circuits of the stator coils.  Is that on purpose?
Anyway, does this motor just consume energy or does it generate some too? What is the O/I ratio and how is it measured?

I have a special place in my heart for pulsed EM motors like that - for example see my analysis of the energy efficiency of pulsed coils in motors of that type.

P.S.
I would give you some money to support this project if I could, but recently my company got taken over by a large corpo and we all got laid-off
I could help you hands-on though, if the machine is in Europe.

[FreeEnergyInfo]

WOW!  That's a huge motor!

Did you build that?
How much time & money did it take to build just the frame and that huge rotor with permanent magnets on those bearings ?

I can see that this motor does not close the magnetic circuits of the stator coils.  Is that on purpose?
Anyway, does this motor just consume energy or does it generate some too? What is the O/I ratio and how is it measured?

I have a special place in my heart for pulsed EM motors like that - for example see my analysis of the energy efficiency of pulsed coils in motors of that type.

P.S.
I would give you some money to support this project if I could, but recently my company got taken over by a large corpo and we all got laid-off
I could help you hands-on though,if the machine is in Europe.

THE MACHINE IS IN EUROPE , MADE IN LITHUANIA

[Grumage]

Afternoon Grum,

But maybe as low or even lower than a metallic contact with oxidisation / burn after a short period of time due to switching?

Good afternoon Hoppy.

Just felt the courtesy to reply with, very true !!  Perhaps Tesla's oil filled system reduced any oxidisation ??

Cheers Grum.

[zcsaba77]

Akula0083 latest TPU videos and screen shots...



http://www.youtube.com/watch?v=vIM5YXS0jKg

http://www.youtube.com/watch?v=zjcgIAJkbRk

http://www.youtube.com/watch?v=UcwXMq3bUZI

Acca....[/font]

hi

this 'wire' core transformer exactly similar with the hungarian patent what did mr. Tamas Pal Cseflo, he give name for his aparatus the CSP (circular switch power) converter. I think Akula goes with same way like Csefko.
here is link to patent:
http://www.cspenergy.eu/lang_hun/szabadalmak_patent11.htm

regards zcsaba77