Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[minde4000]

   Tariel's device does the following, absorbs energy from one point and rejects it at another point. How this is done is the 'secret' but if we compare it to a refrigeration system, that also absorbs energy at one point and rejects at another, we can start to see what components are needed.

   For the refrigeration cycle to do this the four components mentioned above are needed. Lets assume or guess the following:

Compressor--> High Voltage transformer.
Piping system--> Wiring
Refrigerant--> High voltage
Condenser--> Coil A (combines multiple processes into one output) *output of system
Metering device --> Spark gap
Evaporator--> Coil B (combines multiple processes into one input) *Input of system

  Perhaps I am on the wrong track here, but from what I have seen everybody else is. Going forward my direction on solving this secret will be based on designing/experimenting around the above needed components.
  Ultimately these are the components that will be needed.

Respectfully,

Core

Interesting thinking.
And why noone pays attention where (@Kapanadze demo video) Frolov is pointing finger at and the exect words he says? If just someone could reingeneer that device from "gas" into "electric" ... in few pdfs that device HAS BEEN connected as analog to tesla transformer..

Minde

[cosmoLV]

Interesting thinking.
And why no one pays attention where (@Kapanadze demo video) Frolov is pointing finger at and the exact words he says? If just someone could reingene-er that device from "gas" into "electric" ... in few pdf's that device HAS BEEN connected as analog to Tesla transformer..

Minde

you are right, I'm too not understand why nobody pay much attention on that. But anyway it is not so easy as looking (for the first time)
P.S. i don't know why but i feel that user "core" make this device done

[baroutologos]

Gentlemen, I will keep this short and simple.

   An important tile to the mosaic was discovered today. I ask everyone to research SR's comments on the Russian forums much information. Do not just 'Read' his words but 'Listen' to them. Also review Cosmo's comments a few pages back.

  I ran a small experiment that SR spoke about regarding too (2) transformers...

Ok back to experimental talking... What exactly you have found out regarding SR's suggested experiment regarding 2 transformers?

I have conducted naturaly the same experiment as well few russian experimenters as far i remember. Personally i observed no added result.
What was your setup and how you observed an increase in bulb's brightness by the suggested one?

[Dankie1]

The scheme provided by Jesus tells me Kapanadze starts with HVDC then he plays with that .

I am mostly interrested in MEG  , this scheme is from 2009

For a high power density MEG , you need DC 800 volts +

[cosmoLV]

The scheme provided by Jesus tells me Kapanadze starts with HVDC then he plays with that .

I am mostly interrested in MEG  , this scheme is from 2009

For a high power density MEG , you need DC 800 volts +

DC have lot of loses - Tesla worked mostly with AC