Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[aether22]

I wonder if a 3 to 1 ratio for wire lengths/or mass will be important ?

15 50 150 pretty close uh?

If so, wind 52 turn and un wind/tune/cut  for desired freq,then completely unwind and measure ..or weigh.

Then use that mass as reference for input 50+/- hz and output.

Remember Otto? he found  that 1 cm of wire lenght would make bright light or very dimm light.

I am away from my bench for a few days,frustrating , too much thinking!

@stivep you are being "assesed" ..get info out, the target will be big as it already is becomming.
Very nice people  arent they?

I didn't stay around long enough to see Otto get those results, was it the length of close circuits or open circuits that was so critical?

If open then that is interesting and can be explained by normal electrical resonance.

If it was the length of wires that attached to other wires that suggests it is not electrical resonance obviously, far more interesting.

I have seen other devices where apparently the 1 2 3 ratio is a component of their success, good spotting.
We should be aware of unconventional resonance. Moray used radionic like tuning.

[zilano]

@ STIVEP

i know this is a great forum and stivep and team is the leading force here. but i wonder if u chasing free energy then why u r deviating from kapanadze method. kapanadze never used ferrite and he clearly denies using one. he just used a helical coil combination yes with brass/copper tube. why people r digging yoke coils? and even tesla didnt use any ferrite in his coils. in my opinion u must stick to the basic kapanadze. in my opinion kapanadze used avramenko and generated desired frequencies with single capacitor discharge. and even tesla fireball scheme uses single spark gap. well power measurements at the output and frequency waveform is the need of the hour with feedback. i hope u r getting 50/60 hz in the output.

i congratulate u for the effort and teamwork u have shown!

yes u r incredible! sr used a heavy trafo for making 50 hz and he and kapanadze used caduceus coil. a series caduceus coil for output.

although ur efforts r not in vain but need to follow kapanadze way. kapanadze used just a small helical and produced 5kw aim for that.


goodluck and best wishes!
PS: WATCH UR BACK THE AGENCIES R WATCHING U. BE SAFE.

zelina zilano zeis zane
;-)
zzzz

[Rafa12]

Stivep1 JAJAJAJAJJAJAJAjajajAJJAJAJAJAJ (in english HAHAHAHAHHAHA)   what incredible situations! but this is absolutely ridiculous strategy to look what are you doing in your house! It sounds Monty Python sketch!

Well seriously, I don't understand what they would like to find, if you are currently sharing your knowledge to Youtube, Overunity, Energetic Forum etc... be careful.

Here I am ready to switch my cores, modified with all the comments, but I haven't the meassure instruments, and I don't know if they are realy necessary to "clonate" the electricity from the first circuit to the second circuit, and get the phenomenon.

[FreeEnergyInfo]

NEV FOTO ,OSCILOGRAM...
http://freeenergylt.narod2.ru/aidas/

[Tito L. Oracion]

http://www.freepatentsonline.com/1784150.pdf
http://www.freepatentsonline.com/1547154.pdf
http://www.freepatentsonline.com/2622213.pdf
http://www.freepatentsonline.com/2722649.pdf
http://www.freepatentsonline.com/2652460.pdf
http://www.freepatentsonline.com/2569345.pdf
http://www.freepatentsonline.com/1966616.pdf
http://www.freepatentsonline.com/2490081.pdf