Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[semenihin-77]

The biggest mistake - to make the transistor does not work in your operation. Do not try to squeeze out of it what you can, you need to find the voltage at which it issues and is not loaded. It's not that simple. See the instrument and power consumption, and try leaving the light bulb brightness to lower power consumption and voltage. The golden mean - that's the secret!


Delamorto

[garrypm]

Delamorto,

where is the scope connected ?

or

is the scope probe close to the device ?

Garry

[semenihin-77]

Delamorto,

where is the scope connected ?

or

is the scope probe close to the device ?

Garry

Measured with the lamp.

[Jimboot]

Here's my effort  today. I ditched the pipe & ferrite and still lit the 240 25w lamp with one wire. Didn't find the pipe & ferrite added much. What did make a difference was getting the transistor as close to the coil as possible http://www.youtube.com/watch?v=pdsWHRWzYtg

[semenihin-77]

Here's my effort  today. I ditched the pipe & ferrite and still lit the 240 25w lamp with one wire. Didn't find the pipe & ferrite added much. What did make a difference was getting the transistor as close to the coil as possible http://www.youtube.com/watch?v=pdsWHRWzYtg

Transistor 13 007 runs in 2 times worse than the 805, do not use resistors, start pulse from the power supply through a resistor plus 1.3kom.