Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[xenomorphlabs]

forest-Thank you for the clarification. I think Wesley mentioned two grounds relating to his questions or theories about the Kapandze as quoted below.

"But he uses  a lot of load there. I recall  -faucet with cold water pipe  that is ground #1 and -radiator from old automobile deep in to the ground and water poured.   ground # 2 The distance between points of  ground is our conductor that should obey  superposition rule."

If he didn't have to use two grounds then we don't have to include even more theory to make it more complicated then it is.

John

TK even stated that you dont need any ground at all. Source: http://www.youtube.com/watch?v=f1q41KaTwZA&feature=channel_video_title

[forest]

TK even stated that you dont need any ground at all. Source: http://www.youtube.com/watch?v=f1q41KaTwZA&feature=channel_video_title

Sure.Then do you have idea why he used ground ? I think that is important to answer 

[AbbaRue]

@All
Because the subject of Transmutation has come up many times, I though this info would be nice to have here.

Transmutation of Iron producing excess energy
Based on the principles of the Vallée Synergetic Generator:
http://jlnlabs.online.fr/vsg/vsg35.htm


The shorter the Half life the more energy is released in a given time

Only (0.282%)of Iron is Fe-58
Fe-58 Transmutes to Mn-58 with a half life of 3.0 Sec. (Shortest)
Mn-58 transmutes back to Fe-58 releasing 6.250 MeV of Beta.
Making it the best, you get over 2 MeV per Sec out of it.

Then (2.119%) of Iron is Fe-57
Fe-57 Transmutes to Mn-57 with a half life of 85.4 Sec.
Mn-57 Transmutes back to Fe-57 releasing 2.691 MeV of Beta.
This one gives you 0.03151 MeV per Sec. or 31.51 KeV per Sec.

The 2 most common Naturally Occuring isotopes make up (97.599%) of all iron
Fe-56 (91.754%) from Mn-56 half life 2.5785 Hours 3.695 MeV Beta (To Long)
Fe-54 (5.845%) from Mn-54 half life 312.3 Days 1.377 MeV Beta  (Much To Long)

Mn-56 and Mn-54 have to long a Half life, releasing to little energy per sec to be useful.
Because (97.599%)of Iron will produce these, that is why we need a large sample of Iron,
like Thin Iron wire. 

Ideally, if we could get some pure Fe-58 we would have a really good power source.

These figures are based on the info found at this site.
http://www.matpack.de/Info/Nuclear/Nuclids/nuclids0.html
This is the best Periodic Table I have found for this, just click on any element to check it out.

As for Copper Transmutation, Cu-65 (30.83%)is the best:
Cu-65 from Ni-65 half life 2.5172 Hours releasing 2.137 MeV Beta
That's only 235.82 eV per Sec. which is quite low, so I don't think this will work well.
But Iron Fe-58 has potential.

This also brings us back to Carbon which appears to be far better then Iron for this.
B-12 to C-12 Half Life 20.20 MS releasing 13.369 MeV of beta.
That's 13.369 MeV in 20.20 milliseconds. Or about 13 Million Volts at 50 Hz.
A whole section of this forum was devoted to that topic a few years back but died out.
I believe the biggest problem was getting the magnetic field and frequency just right. 

But Maybe! Iron will work better because of it's magnetic properties. 
In order for NMR to take place a magnetic field of a precise strength must surround the sample,
as the sample oscillates at a precise frequency. 
Iron being magnetic will solve this problem, because the very atoms will be surrounded by the magnetic field.

Of course this is based on the theory that NMR will cause Transmutation to take place! 

[stivep]

Hi Wesley, maybe he can film it then with a normal camera and he could place a normal 100 Watts bulb besides
it beimg lit by normal AC voltage, so we could compare the brightness ?
Many thanks in advance.

Regards, Stefan.

He does not have regular camera, he does not have  photo camera, Most of the free energy activist in this part of the world do put last possible resources into the project.
I have send to Aidas BNC 625 generator that I have purchased from ebay in Israel. The seller contacted me ..and Aidas contacted me. Generator was returned after Lithuanian took money from Aidas 1200 lit= 3 times amount I paid for used generator. as fee for custom..
Than generator was returned  as is not approved by UE but money has not been paid to Aidas back.
Than I paid additional $45 to get it back to US...
Second generator was send by me  from US to Lithuania using private carrier  by sea 8 weeks and was not delivered to Aidas as of yet.
If I will decide to go to Lithuania I'm going to bring him few generators extra.
AS US citizen I should have no custom fee...It is my property and I can do with it  whatever I want.. lose it give it or pay for say ...costs of accommodation  using generators as monetary value... There is no  regulation in this area ..I'm allowed to even to  destroy it...in any land including Lithuania.


Dear Stefan I have  big respect to you personally and I think you can understand
That over 20% VAT does not apply to me...
and that cost of used laboratory equipment is the cheapest in US.


It would be nice to ask for help from FE.community...
I'm not willing to ask for it.
I was offered 100 000 000 EURO today ............




For everyone of you.........here is the message

money YES.......... but not for keeping my mouth shut.
That will not happened......
EVER!!!!!!!!!!!!!!!!!!!!!!!!!


Wesley
I want to keep my life the way it is.............
I'm not rich and I'm not going to get rich this way..........

[John M]

Sure.Then do you have idea why he used ground ? I think that is important to answer 

To me it sounded like he said "grant is not needed". I tried to determine the context it was said in but could not for sure. More than likely he said ground was not needed, but was that just for lower power or even high power.

John