Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[cheappower2012]

@a.king21
A simple question did you measure the voltage at the plug of the heater,
if you did what was it. was it AC and at what voltage.

[a.king21]

@a.king21
A simple question did you measure the voltage at the plug of the heater,
if you did what was it. was it AC and at what voltage.

Sorry, no. At the time we thought the negotiations were going well and this was just an initial demonstration. However the heater was handled and behaved normally - no shocks or funny sensations or noises. Mike had one of those heaters  when he was younger and said everything about it's performance was just as he remembered an ordinary heater plugged into the mains would behave.

[frantz]

Sorry, no. At the time we thought the negotiations were going well and this was just an initial demonstration. However the heater was handled and behaved normally - no shocks or funny sensations or noises. Mike had one of those heaters  when he was younger and said everything about it's performance was just as he remembered an ordinary heater plugged into the mains would behave.

Do you remember something what is invisible on pictures,  like some large parts inside black box...?
Maybe you saw transfotmer or caps?
This info could help.

[stivep]

Tariel Kapanadze Aquarium2 Video de-bug
http://www.youtube.com/watch?v=VPknKQFrmqY
This  is the best I could do to make quality better.




Please note that in the  video I have  compared 
outside of house picture of concrete  floor made by  mr  King team few moths ago and
my picture of the same but with no cement in it in 2011 in September.


To make ground  and if you want to make  quick and good you drive copper  rods into it
about 4f  than you put clamp on it.
The  cement was done  fresh with one screw to it?
please ask yourself questions I  have  mentioned in video and look at  pictures comparison




Wesley

[cheappower2012]

@a.king21 that's too bad that no voltage measurements were done as it leaves a bad hole,in the green box video because
the voltage source is passed thru a coil ,it gets pulses that interfer with ac voltage measurements,
I posted a demonstration of this effect.Because the 2012 device has no pulses passing thru the source voltage you should have got a good voltage reading,you have to remember TK and SM with whom I have vast experience
are masters in the art of deception so it makes figuring out there secrets incredibly hard,as an example
SM fooled many top electronic engineers,made them look like complete fools,TK is on that level too.I didn't think TK was on that high a level of deception until you posted your picture of the 2012 device.