Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[zcsaba77]

Energy problem is solved!!!!!!!

http://www.youtube.com/watch?v=mS9y0IUspbs

[Zeitmaschine]

I claim that space (and time) of our daily lives are just geometric reference systems and their only properties are magnitude and direction. 

Supposed there is only space (we are alone in space nothing at all around us) then how to measure the magnitude and the direction of that space? How can I measure a direction when there is no reference point to determine an angle? How can I measure the magnitude of space when there is nothing in this space hence I do not have any point of reference? Perhaps we should drop the properties magnitude and direction as well. When we define space as »nothing« then this nothing cannot have any properties.

Here are more outlandish conceptual errors ... err ... ideas:

The Earth's electric field is all around me. Now I take a Faraday cage and then I close it (could be a metallic cooking pot with a lid). The laws of physics now say a field captured inside the cage creates an electric charge on the inside-wall and an opposite charge on the outside-wall. Now I take a wire and short-circuit (maybe through a load) the inside with the outside of the cage's wall. This should briefly generate an electric current. After that the potential difference is gone and the field inside the cage is also gone (exactly like with a charged capacitor but this one has only one plate closed-looped by itself). When I open the cage again a new electric field from the Earth can flow in to re-charge the cage. Because the Earth's electric field actually is very faint (but on the other hand inexhaustible), it would be an idea to do this 100.000 times per second or so.

Thus just a strange thought: Could it be, that the tin can on Kapanadze's table itself is the source of the energy coming out of it?

Anyway, the basic idea here is that when an electric field is surrounded by a metallic shielding (Faraday cage) then this shielding acts like a charged capacitor with one three-dimensionally looped plate (sphere, cylinder, box). The positive charge is on the outside and the negative charge is on the inside of that plate - or vice versa, don't know. Maybe that depends whether the cage is grounded or not.

But at least the one-plate capacitor is a new conceptual idea here on page ...

[captainkt]

@Zeit, Obviously your Faraday cage outside surface must be insulated from inside surface so how do you think Kapanadze does this with what looks like an all copper box with a switch on top and a 15 mm hole for a load of wires to go in?
Regards
Keith

[Zeitmaschine]

No problem with the holes when properly shielded. The problem would be the switch and its metal mounting. And just by chance the mounting of that switch looks very odd. What we see as a massive copper plate could be just copper-clad board material with no copper on the inside. So there is shielding form the copper on the outside but the plate is non-conductive on the inside.

Interesting ...

[andrea76]

I just spoke with Joseph Newman on the phone. He told me that he had looped the machine and it was now a perpetual motion machine.


My concern was the cost of production per kwh. He was very evasive.
I pointed out to him that solar panels were an alternative.
I asked him what was the cost of manufacturing a 10 kw unit. ie  a Newman machine which could produce 10 kw.
He had no answer and basically cut me off, very rudely.
Not a gentleman at all.
I wouldn't give him a penny.
However his technology works.  We need to find a way to reduce the miles of copper wire his device uses.

increase the frequency.eg:Prentice work on 500 khz and one half mile wire,but the current is DC to optimize the device.IF kapanadze pulsed the secondary (long wire) instead of the primary of Tesla coil for create ,in resonance,the standing wave at the speed of light?the copper tubing is only one load protection and control of the correct  operation. the load is connected only after a few seconds