Selfrunning 3 KWatts ERR unit powering 3 x 800 Watt lamps

[EMdevices]

I'm surprised nobody mentioned the properties of bismuth and that it is diamagnetic. 
Here's a link to levitating magnets using bismuth.

http://www.fieldlines.com/other/diamag1.html

This EER device, could very well be simular to a generator I saw a few years ago.  Due to the diamagnetic material, a coil will begin to self resonate.  He does say he uses a transmiter (to stimulate the plates)

Interesting device, I hope it's not galvanic action
EM

[powerunlimited]

What does everybody think of this true or false



posted by power technology  September 11, 2008, 01:52:31 PM on elemental rod thread


Hi,

I am new to the group. The reason that I joined is because someone
told me that this is the best alternative and free-energy group on the net.
My partner and I are always on the lookout for the elusive Free-Energy Device
that really works. I was really surprised to see Dr. Schwartz's ERR
Technology being discussed in the group. My company is very familiar with his research.     
I first met Dr. Schwartz back in Jan. of 1998 when my wife and I went to the Philippines
to visit her parents. While we were there her father asked if I would like to go with
him to a lecture at the University of the Philippines. The lecture was about alternative
energy given by Dr. J. B. Schwartz from the Noahs Ark Research Foundation. The
lecture started at 8 am and ended at 12 noon. During the whole four hour lecture
Dr. Schwartz powered his public address system, an old 17 in. black and white
television and two 100-watt
light bulbs. He spoke about many different kinds of alternative energy but the
one that I was most impressed with was has Electromagnetic Radiation Receiver that
he was powering all his equipment with. At first I was skeptical about his ERR as
he called it because it looked too small and light to be used to run all his equipment.

His ERR device consisted of two rods which I believed to be nano-tubes, two copper
coils on two very strong magnets about an inch or more apart, a complicated looking
circuit board, a small DC volt meter and some three prong electrical outlets all
mounted on a thin piece of plywood. At the beginning of his lecture I noticed that
the reading on the voltmeter was reading 15.4 to 16.6 DC volts and after four hours
later it was still reading the same.

I asked him if the ERR could be moved from the table to another part of the room and
still produce power. He agreed and unplugged his pa system and allowed three people
from the audience to carry the ERR, the television and the inverter to different parts
of the room and it didn't seem to affect its power output at all. We were also
allowed to examine the table and it proved to be a light-folding table. I found no
source of power other than the ERR itself. The only thing that I found to be strange
was when I used his metal ruler to test the magnets; I accidentally put the ruler
across both magnets and the power shut down. Dr. Schwartz seemed to be a little
upset because of the difficulty pulling the metal ruler off the magnets. After
the ruler was removed the power came back on. When I asked him why the power went
off he said that I shouldn't short the magnets because it could damage the
unit. He seemed irritated with me so I didn't persist any farther.
         
After his lecture I asked him if he could meet with my company to talk about
possible investment in his ERR technology but he didn't seem too interested
in taking to investors.

Soon after returning to the US I was able to convince my partner that it would be
worth it if we donated $100,000 to the Noah's Ark Research Foundation.
About a month later the money was returned to our bank. After many emails
Dr. Schwartz replied, I don't except money from investors.
I figured that he was pissed at me because I shorted his unit. I later found out
from a source in Arizona that hes financially well off plus hes
a save the world freak and a very difficult person to work with.

My partner thinks that he must have been transmitting the power from outside the
room and picking it up with his ERR but I don't think so. He also thought
that he made bank interest on our money before he sent it back so I checked with
Dr. Schwartz's bank and they said that no interest was made on our money.
They said that they had instructions from Dr. Schwartz to return the money to the
sender and that he didn't give any reason.

For several years I hadn't heard much about Dr. Schwartz's ERR until
2003 when I went to Japan to see a device at the University of Tokushima. After
seeing both Dr. Schwartz's ERR back in 1998 and the one at the University
of Tokushima in 2003 I'm now convinced that both are using the same
basic technology.

[markdansie]

@powerunlimited,
nice post.
I believe the account was true and accurate. It still doesnt explain how it works but shows a different perspective to Mr Shwatz.
I still am not sure of his motive, given now it does not appear to be money. However by releasing or at least licencing the technology the project could be rapidly accellerated.
I am sitting on the fence with this one and guess will have to be patient. This is highly unusual for me given my usual shoot em down guns blazing appoach.
Mark

[janne808]

I'm surprised nobody mentioned the properties of bismuth and that it is diamagnetic. 
Here's a link to levitating magnets using bismuth.

http://www.fieldlines.com/other/diamag1.html

This EER device, could very well be simular to a generator I saw a few years ago.  Due to the diamagnetic material, a coil will begin to self resonate.  He does say he uses a transmiter (to stimulate the plates)

Interesting device, I hope it's not galvanic action
EM

Yeah I guess a sligthly less probable alternative would be that it's one of those old radiant Tesla ideas coupled with some metamaterial focusing.

[Harvey]

@powerunlimited,

I have no problems with that story from a content perspective. I have been told that Dr. Schwartz has given lectures in those locations and in India as well. I have not asked how many lectures or everywhere they have been given.

I do recall Dr. Schwartz saying that during one lecture, a thunderstorm became active about 20 miles away and this had the undesirable effect of over production in the unit which began smoking and he had to pull one of the control wires off to shut it down.

As far as the truthfulness of the post otherwise, perhaps you can contact the author of the post for verification of his particular experience. The story does corroborate some of what Dr. Schwartz has stated.