Bloch wall disconnect and reconnect. The final design!

[giantkiller]

So my next step is to use the Vari-cap to tune the tank to the natural res freq of 188k. That will give me a capacitance value. With the 2 windings at the same res freq I can ring the second one with the primary. Don has a cap on the primary. I know he says 'or you don't need caps'. But that is a ruse and a true statement. Spread the windings or use the correct wire length. Don never mentions 2 freqs. Sm does but that is a ruse also. If I have 2 coils I can say '2 frequencies'. There is a frequency here and a frequency there. Sneaky that is all. A derisive clue.
I have played the investor game to at millions of dollars per contract. I know how to double speak in the game. To hide things or knock status quo engineers out of the saddle. Rabbit trails. Don is just hinding things. Just like the others who have something simple.

Back on track.
But the biggie is to then take a pvc wound coil and spread the windings to see what cap-value is there. I can have no cap device but have spacing, cap and no spacing, or just spacing.

@wattsup,
I have a 2 wind of 1/4 diam aluminum. Will put the 24awg copper on it tonight. I also have stainless steel wire. If I don't see what you see then I move on.

[bw]

starting at 3:25 on this video two waves are shown running just out of sinc.   is this another clue?
http://www.youtube.com/watch?v=WhuAAcM2JLA&feature=related

[forest]

Where can we find this picture Smith is presenting at 3:25 of this video ? This looks like important factor.

[bw]

Forest, I thought this is important too.  Looks to me like this wave gives a second peak at perfect timing to assist the first wave.  I'll search for better photos or source.

[giantkiller]

I too, would like that pic or book, please.

In trying to find the capacitance of the natural frequency I have .1uf in parallel with my L1. The cap for the secondary is .0056uf. The frequency is 188khz. I need to find the cap for the 7 turn feedback winding next.
I am keeping things as static as possible based on the input frequency. I want to transfer this to the end stages. When that is done I will change the frequency. When the ratio of the windings change then the caps change also. When I get all stages resonant I will raise the voltage.
I have not found the res freq of the feedback winding but this is not a show stopper. I wound by count. I am surprised so far by the same resonant freq by the L1 & L2. The feedback winding will probably be a surprise too. The simplicity of it allows windings added or subtracted.

Smith's four vertical coil setup is very similar to the youtube vid of a room full of spinning magnets.
In 1996 Muller, Smith, & Stev Mark all showed suitcase sized devices the ran electrical equipment.
Who is faking what here?

--giantkiller.

Where can we find this picture Smith is presenting at 3:25 of this video ? This looks like important factor.