Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Best metal for this setup?

Started by Farlander, November 05, 2009, 12:18:39 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

Farlander

November 05, 2009, 12:18:39 PM
Hi everyone,
So I've been away for a while, but I'm back working on the cell and I have a lot of equipment at my disposal now.  I have a plate cell design, with 2 rods (or bolts) going through the center of the plates, with every other hole being just larger than the ones on either side of it so that no contact is made.  The rods are going to be supplying the power.  My plates are 304 grade stainlees steel the question is what can I use as rods?  I think 1/4" diameter would be large enough, would stainless steel bolts work?  They are very magnetic unfortunately and I suppose they would rust.  The rods should be able to carry 40 amps underwater and not oxidize too much, I heard gold platinum and titanium were good but don't know where to find them cheaply.  1/4" by about 4" long x2 pieces should suffice.  Thanks everyone.

ramset

#1
November 05, 2009, 07:51:31 PM
Hi
gold brushplating might be a cheap way to experiment with gold
If you wan't more info on this Pm me
Chet
Whats for yah ne're go bye yah
Thanks Grandma

dankie

#2
November 05, 2009, 08:36:34 PM
No way , bad idea .

Invest in a hydrophone , for about 60 to 200$ , it picks up vibrations in water and will show you a maximum oscillating frequency  of your tubes . They use this for oceanography and listening to fish and dolphins etc ...

Then use this and match the impedance of your circuit using algebra and kirchoff sio that everything is matched .
Print
Go Up Pages1
User actions