STEORN DEMO LIVE & STREAM in Dublin, December 15th, 10 AM

[Jimboot]

Ok bought a scope from Jaycar today.... now I just have to work out how to use it! LOL . Took my Ossie motor down there too to show the guys what I have been building. Even one of the biggest sceptics down there got a bit excited & offered a bunch of advice. Once I've worked out how to use the scope I'll post some shots. From what I can tell I should just be measuring what happens over the coils right?

[Jimboot]

1st scope shot across the coils on 6V running at around 5000RPM . 2nd is running on a D cell at around 1100 RPM

[captainpecan]

What an anti-climax! 
Not only do steorn not have it available on their website, they're still showing the loop ad for it. No one has yet uploaded it to youtube either... I wish I'd recorded it now - there was a couple of screenshots I want to take a look at again.

Here's what I found so far...
http://www.youtube.com/watch?v=xkKPfhQgEVk  Part 1...  That's all this user has uploaded as of this post.  Make sure to check his channel to see if he has the other parts uploaded, as I'm sure he's working on it.

[Omega_0]

A screenshot of the output vs input, as shown in the final demo.
The trace going uphill continuously is the output power in the pickup coil (which was shorted, so its R*I^2)

The pulses are the "net" input power going into the input part of the system (i.e. the toroids). It is not clear what the "net" means here, but I guess it must be the sum of power fed and power collected back from the collapse. Not sure but.

He said you can work it out and the output would be 300% of the input. So, there you have the proof. Enjoy

I agree, that it was not as clear cut as expected, and like others I also feel disappointed, because I was waiting for some solid proof. But it is better than nothing at all. Hopefully, when all the raw data is posted on their site (as promised) we will know for sure.

If you watch the (short) demo, he divulged more info in those 5 mins as compared to all the combined info given out in last 4 years.

[captainpecan]

Hopefully more of the demo will become available quick.  I would like to see it again, and pick it apart, and just make sure I am not missing something.  The more I think about it, I really would like to see how they hooked up that scope again.  My internet was choppy so I missed some words here and there, but I think they had one generator coil hooked up.  They had that one generator coil directly shorted, and the output scope trace was from that one coil alone I believe.  I could be wrong on this of course, I do not remember for sure.  But running this through my mind, tells me that something is bogus or I definitely saw it wrong, which is possible.  But, it appears that they were saying that one pickup coil was producing over 300% of the electrical energy going into the system.  If they were using a little over an amp as Sean stated during a question, then they had to be pushing a little over 1 watt input.  That means somehow they are claiming to be getting over 3 watts output from one common wound pickup coil, with a rotor with small magnets on it rotating at a mere 1200 rpms.  I want those coils, because that would be some amazing output for an air cored coil, low rpms, and close to 1/2 inch magnets.

I will of course try and keep an open mind, and see what others here think after everyone has gotten to watch.  Maybe I expected to much for proof of OU.  But I must say, I was hoping for more than a simple scope trace that shows input measured in a different manner than the output.