Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



STEORN DEMO LIVE & STREAM in Dublin, December 15th, 10 AM

Started by PaulLowrance, December 04, 2009, 09:13:07 AM

Previous topic - Next topic

0 Members and 31 Guests are viewing this topic.

PaulLowrance

Attached image is my interpretation. Red is the coil wound toroid. So you have magnetic field going vertically from one magnet, through the toroid, and into the other magnet. The amount of field going through the toroid depends on the toroids effective perm. Apply current through the toroid windings for typical magnetic material will decrease the toroid perm. Magnets rotate away from the toroid, thus requiring less energy to escape.

Trust me, there's a lot more details involved. The magnet also changes the effective perm for the toroid. If everything's not right, then there's a big loss in toroid due to a change in perm.

A little more details. After applying current in the toroid, half of the toroid perm increases and the other half decreases for typical material. When the magnet leaves the perm changes once again.


PaulLowrance

Where can someone buy good priced bearings in north America?

tak22


PaulLowrance


Omnibus

Regarding @alsetalokin's (TinselKoala) back emf (BEMF) experiment:

This is an example of bad science: http://www.youtube.com/watch?v=js24ZZ_6Je0.

Change of magnetic flux that is supposed to cause the BEMF, which is the main focus of attention here, is the change of flux caused by the pulses of current flowing through the coils. Thus, it is the emf causing these current pulses through the coils that is the subject of study here. Whether or not there is a permanent magnet nearby these coils is only a condition which may or may not change the studied emf. If that studied emf changes then there is BEMF generated. If that studied emf doesn’t change then there is no BEMF generated. In Steorn case the studied emf remained the same throughout the entire experiment despite the presence of permanent magnets near the coils and even despite their turning at various rotation rates.

Emphatically, the subject of study here is not the change of magnetic flux due to the motion of a permanent magnet that is supposed to cause emf (BEMF) in a nearby coil as the author of the video http://www.youtube.com/watch?v=js24ZZ_6Je0 really wants us to believe. The gingerly activity of this author in the forum, supported by another ginger activist, will not change above fact and anyone caring for the scientific side of this debate should take note.