Mostly Permanent Magnet Motor with minimal Input Power

[DaKrampus]

Same here

thank you luc for pointing me to this thread in this forum.
I am very impressed!

The only question I have is: how do you get to 0.78 volts...
This is not a voltage I would have preset on my power supply.. I meen I probably could as it is a lab grade power supply where i can preset anything between 0.1 and 30 volts and 0.1 and 5 amps..
but I would not have set it to 0.78 by intuition.
so i was wondering.. is there a special reason?

Luciano

[gotoluc]

I was having some Youtube link problems with the above link which was going to the previous video even though it was a different link

It's fixed now

Luc

[Farmhand]

Luc, Aren't you just getting closer and closer to 100 % efficiency ? And when you get the best possible efficiency you can get won't
that be the closest to 100 % efficient you can get ? Is there an efficiency rating for those lifts and what an OU lift would figure as ?

Please forgive my "Apparent skepticism" and feel free to ignore my questions if you wish.

..

[woopy]

Hi Luc

Thank's very much for sharing

Beautifull work great bravo

Can't wait for the next videos

Laurent

[synchro1]

Hi everyone,

here is a quick 2nd test of the Triple M Super build.

Link to video: https://www.youtube.com/watch?v=f6pc-XNS9uo

The results are for one coil and two wire strand connected in series


The simple 1 inch wide Triple M Pulled 500g for 0.43 Watts

The 8 inch Super build single coil one stand gave a result of 2Kg Pull for 0.43 Watts

and now the 8 inch Super build single coil 2 series stands gave a result of 2.5Kg Pull for 0.43 Watts

So by using only half of the 8 inch Super Build we are pulling 5 times more then the one inch build

Stay tuned for the full results of the Tandem (double) Triple M Super build

Place your bets on what you think it will pull for 0.43 Watts

Luc

@Gotoluc,

Are "2 series strands" the same as "Series bifilar"? I forecast a very exciting historical precedent on the approaching horizon!