The Ossie motor

[jbignes5]

Have you guys tried using a cap pulser circuit with the rodin coil design with lower resistance coils? My thinking is get the resistance as low as possible and burst pulse the coil to get a stronger effect through the lower resistance coils. This way you get maximum effect of the field and no direct short of the source supply. The lower the resistance the more intense the field will be.

jbignes5

[pablo]

Dear Ossie, Jimboot and All:

Please forgive my basic questions I am new to this material.  I have been following the development of the "ossie motor" since the original paper and set up by Ossie on through the builds by JLN and Jimboot.  My questions:

1)Am I correct in assuming that the in Ossie's build of March 21  2010, build charges the batteries when the reed switches cut current to the coils and the coils release their voltage spike?
2)What is the purpose of the rotor with magnets given that the coils receive their charge from the batteries?  That is to say a moving magnetic field near the coils is not needed to charge them.

Thank you for your time in answering my basic questions.
Pablo

[Jimboot]

http://www.youtube.com/watch?v=cBT3PRCubk0
Building this for a pulse motor build off with Russ gries. Rpms up to 4600 rpm now and voltage up 500mv this thing does my head in

[Jimboot]

Rims over 4700, volstge up will get scope shots tmrw

[Jimboot]

RPMs this morning had risen to over 5000 with a continual run of 14 hours. Battery voltage looked to have slightly increased. I'm hoping it hasn't shaken itself apart by the time I get home tonight.

http://www.youtube.com/watch?v=maUJP3nz3xw&feature=plcp