GBluer(Slayer) Exiter

[shylo]

Hi all , This may be a really stupid question ,but how do I know which pins to connect to on the transformers??The one I have in front of me has 10 small pins ,3 big ones soldered in the circut board and 4 wires coming off the top of it. I just read about these things a couple weeks ago. I have very little knowledge having to do with electronics. .......any help would be appreciated...........thanx ....shylo

[conradelektro]

@shylo, fly back transformer pin identification

At the moment I am looking at fly back transformers myself, this might help (advice from Jean-Louis Naudin):

http://lifters.online.fr/lifters/labhvps/tht.htm

In case your fly back transformer has some writing on it (combination of letters and digits), you might find a data sheet on the internet. Take a photo of the face of your transformer that show some writing and post it.

Greetings, Conrad

[shylo]

Hi Conrad I don't have the means to post a pic ,I should get one of those camera phones. The numbers on this one are Sampo   0145    FE1B4OAT   FM 1057. Thanks for the link I'll check it out.      shylo

[slayer007]

Here is an easy way to make a Slayer Exciter if you don't want to wind a big coil.

The L1 is a Ferrite Loopstick Antenna Coil for a crystal radio.
The L2 Primary is 9 turn of 23 awg mag wire.

The circuit is just the basic slayer exciter with a 1M resistor and a mpsa06 transistor.

http://www.youtube.com/watch?v=lBA0qY0IbPI

[slayer007]

In this video I just wanted to show the circuit I used in my last video.

And show some of the wireless range of the Exciter.

http://www.youtube.com/watch?v=8-CQAzC10FM&feature=channel_video_title