The Bucking Magnet Motor

[z.monkey]

Thanks Jesus,
We always need options...

[wattsup]

@z.monkey

I would like to applaud your building effort and hope it pans out well. Your design touches many points of a design I had done a good while back that you can see here.

http://purco.qc.ca/ftp/Wattsups%27%20stuff/dual-stator-magwheel/

Just click on the jpg file.

Maybe this can be another idea since it shows three magnet layers with only the center one in rotation. Being in the center, the inner and outer magnets can act on both sides of the center rotating magnets.

As well I am happy to see you magnets are angled to use only half of one polarity to provide the directionality. Can't wait to see how it goes.

Keep well and good work indeed.

wattsup

[z.monkey]

Thanx, Wattsup...

Your design is symmetrical, yes, I addressed that.
Are you up to making a new one?  Just change
the angles a bit, LOL!  I know, these are lots of work
but maybe we can build it better...

Thanx again...

[z.monkey]

Name change...

I think the stator, the center spinning part, should be called a repellor...

The method of drive is repulsion, so it is repelled, hence its the Repellor...

uulgh... Marketing...

[wattsup]

@z.monkey

If you are the repellor, then everything must move away from you, and not you move away from everything. If you move away from everything, then you are the repellee. So you in fact have a repellor and a repellee. The repellee is being repelled by the repellor. (lol) But that would sound too confusing. That's why I think it's always best to use something original like the words "stator" and "rotor". Just play'in around with them fun words.