New permanent magnet motor on youtube from Roobert33

[McGiver30]

I also drilled out small rubber balls to go around my rod magnets, and when I put them between my stators it goes around. I have not been able to have the time to improve it, but did put in a request with clanzer to in the future machine some stuff for me(since he does good quality machining).

[Omnibus]

see that picture of that flexible track chet? do you understand how it 'wraps' around the 'hub' of the magnet motor? now imagine the W-track wrapped around a 'hub' and the magnets go where the green lines are...

Yiu should restrain from posting crap such as the above because in this way you're clogging important discussions.

[CLaNZeR]

Okay got the V-Track mounted on Rotor.

Pictue and video below, back off out into the workshop !

http://www.youtube.com/watch?v=lq8T7_ZQNTQ

[nievesoliveras]

@clanzer

Great job!

You and @zmonkey are the best making the parts needed for a project.

Jesus

[bourne]

@ ClaNZeR I posted this on your utube video but I will repost it here for @everyone

Very nice Clanzer, as usual!

I feel I have to mention, on the original video, the Spring that was supporting the vertical rod, I would say, was adding its own dynamic to the lifting and drop from the cams passing.

By being slightly compressed at rest and able to compress past the rest position when the slide assembly drops it will add 'more' of the 'random hand movement' required by the 'Hammell device' idea.

The tiny damped oscillations of the bouncing top bar 'might' be beneficial towards 'un-sticking' the sticky spot.