New permanent magnet motor on youtube from Roobert33

[ramset]

Well
Stephan should call this man!
I just hung up the phone with "Rob"[not roberto]
From the above posted #
And he is a swell guy!!,a gentlemen!!

Some brief info on Robs config[the green Mr. hand one]

One side of the V is all "N"
One side is all"S"
He told me the Mag at the top of Roberto's is attraction
And also at the bottom[attraction]

He has NO PLANS to sell, has no intentions of selling any!
He's building one with the drum STATIONARY and four
bar mags on the INSIDE of the drum that spin inside the stationary  drum,
He said his is different than the guys in Germany [didn't push that ,I'll let Stephan ask].
He said I could call back when I have more questions regaurding replication [that is Stephans call too]

He says it Works as shown!!

Chet

[xee2]

@ ramset


If you talk to him again, please ask how long it has run continuously. I assume it will run forever, but what is the longest he has run a test for?

[Omnibus]

@All,

Just spoke with Rob too. Basically he told me the same things as he told @ramset. One leg of the V is N, the other leg is S. The magnet on top is magnetized through the length. Same is the mag at the bottom but shorter. The drum of the rotor need not be made of metal, can be plastic but has to be light. Positioning of the elements (mags) of the V can have some discrepancies as seen in the video. The arrangement need not be perfect. All in all there are no special requirements and can be made with less effort than initially thought, save for the form of the cam, especially crucial for the timing. The principle resembles very much that of Walter Torbay's motor we discussed at length here in this forum couple of years ago. Also, turns out, Rob is the guy who proposed the design in question some months ago that was discussed here in this forum, as I already mentioned. Now, the guy who posted the video just took the design and made a real working device. Rob said he doesn't know who that guy is and where he's from and that he (Rob) also used to have an actual working model but didn't feel the need to go public with it. He says this contraption does work. That's in a few words the conversation. If there's anything more I'll drop another line. Let me add also that I too find Rob to be a very fine man, open and forthcoming.

[ramset]

Omni,
Thanks,This ball is in your court now ,much more capable hands then myself.
I will not make anymore calls to Rob [unless absolutely necessary]


Chet

[CLaNZeR]

Sorry if a bit lost on this one guys.

So this Rob you have been talking to on the phone, is Roobert33 who posted the video?

Cheers

Sean.