The Gabriel Device, possible COP=8

[Magluvin]

In Teslas pat, he talks about getting the primary to break through or penetrate the shell, or shield, that is around the secondary. 

I would see this as what you have shown. As the primary voltage rises from 0 volts, there will be a point in the rise that the shell is saturated and then penetration.

Ill think of some things you can try after I reread the pat, maybe it will help.   Ill see what I can do.  ;]

Have you tried other freq of input?

Mags

[Magluvin]

I dont know if you read it, but here is the pat. Have to get to sleep. Will be back tomorrow.  ;]

Mags

[matthewklinko]

I dont know if you read it, but here is the pat. Have to get to sleep. Will be back tomorrow.  ;]

Mags

Hello Mags, I've read that patent many times, its very interesting.

Though I do think that's its still the inner core that's saturating. because if I drive the current down to a point where its not saturating and load the core , the bulb will light up, and the output will be a clean sine wave.

then if i further increase the current the bulb will get brighter till the core saturates and from then on the bulb stays the same brightness and the sine wave output it distorted like in the photos.

If the shield was actually shielding the secondary current wouldn't flow in the secondary until the shield saturated.
So either my shield isn't working, or its saturating too soon that I don't notice.

My shield is a 3" mild steel donut.

I'm trying to get my hands on a 3" CRGO donut at this time to see if it makes a difference.

[Mavendex]

http://www.free-energy-info.com/Combine.pdf

lots of good stuff in here

[bear43]

   Making cores

Have you made your own cores with epoxy or resin mixed with 1 or more of these.
I have not yet, any other mixes that mite be a good to try.
-iron filings
-iron powder
-iron oxide
-xerox developer powder
-black sand