New magnetic-gravity motor chasing its tail from Tom

[vrstud]

put some blades on it and call it a ceiling fan. LOL


Would love to see some pics or video for this.

[forest]

 

The titanium rod I need is 3/8 inches in diameter, 5 3/4 inches long, with a 1 3/8 inch tread on one end of the rod.  16 threads per inch.

To hard for me to cut and thread with the equipment I have. All I would do is scratch up the rods surface.  I already have a 12 inch section of rod to work with.

I am trying for the most uncomplicated/inexpensive route to do all of this. Patenting can turn into a costly mess which will go no where after spending a fortune.  Anyhow I already know the US patent office does not take patent applications for overunity or perpetual motion devices.  What catagory this device might fall into is unknown to me   Two magnets repelling each other while turning clockwise in my case.

The last sentence got me thinking : is this the only direction of rotation or can you turn it counter-clockwise ?I wish I could see your device running on opposite hemisphere ? what do you think about it ?

[gyulasun]

Or describe it as a wind generator that needs less wind surface area... 

[hartiberlin]

This is something interesting! I just setup a few simulations in Maxwell based on this idea, and I think it actually works. Even better, after some changes, it can be made to work even without using gravity.
This is good because in this forced condition without using gravity, it could operate at very high RPM. The simulation uses a 3" diameter disk 1/8" thick and two cylinder magnets 1/2 diameter 1" long. A ball pivot point 1" above the disk magnet center. The two other magnets are used in different ways to create the forced condition and to provide .018 Newton meters of torque on a rotating disk mounter below the 3" disk magnet holding the two cylinder magnets.

I don't want to say too much as it's not my idea, but the simulator indicates it does work!
I will probably build one myself for testing and report back if it works or not.

Thanks Tom,
I had this same idea many years ago, but could not put it together.
It was your success that renewed my interest!

Great Lumen !
Please post some simulation output pictures of your simulation or
if you can also a GIF Animation or youtube video from
sequenced single pictures into a short movie.

Many thanks in advance.

Regards, Stefan.

[maw2432]

Thanks again Tom,   

I am sure your soon to come (in the next few days or so) video will give the OU community a real lift.   

I am looking forward to it. 

Bill