Testing the TK Tar Baby

[Rosemary Ainslie]

Hello MileHigh,

I've answered you here...
http://www.energy-shiftingparadigms.com/index.php/topic,2311.msg2440.html#msg2440

Take care there MileHigh. 

Rosie Pose

[TinselKoala]

So there, MH, she can insult you and libel you and lie about you and what you say and do all she likes on her own forum where nobody can challenge her.

And she will continue to do so, until... as usual.... her sycophants fall away as they learn the truth, she alienates the actual forum owner/maintainer, and the cycle repeats yet another year.

Meanwhile, today on July 1, 2012, her "official" publication of her "paper" on Rossi's Journal of Nocluelear Physics Blog.... is still there and still contains the miraculous lie about 5.9 megaJoules and "bringing water to boil" when the experiment described did NO SUCH THING at all. "The water wasn't actually boiling but there were tiny bubblies." Aww, innt that cute. and 5.9 megaJoules ! Over a KILOWATT, continuously for 1.6 hours !! No wonder all the water was boiled away and the little broom closet became unbearably hot.... OH, WAIT.... it DIDN'T.

Ainslie lies and misrepresents and commits scientific FRAUD each and every day that that paper remains up, UNCORRECTED AND WITHOUT EXPLANATION, on Rossi's "Journal" site, containing, among other lies and misrepresentations, the lies shown here:

[TinselKoala]

Here are a couple of videos that might help to explain a little bit about the behaviour of mosfets switching a high-side low impedance load.

http://www.youtube.com/watch?v=tKstLQYayNA
http://www.youtube.com/watch?v=gbAGWkWFmxM

Of course, one would actually have to WATCH them to be able to comment coherently.... and, for some people, not even then.


However, I am confident that any of Picowatt's soldering students could grasp what is going on and be able to teach their playmates everything an eight-year-old needs to know about mosfets. It's too bad that Ainslie isn't eight years old.... she might actually be able to learn something if she were. But it's far too late to expect Ainslie to learn anything at all; she still can't even draw a circuit diagram. She even has the mosfet connections wrong in her cartoon explanations in the second paper-- which is also still up, with all its mistakes like the wrong connections in the cartoons.

[Rosemary Ainslie]

Hi Guys,

Just be advised that Glen, like TK - ALWAYS gives insubstantial reference.  It's required for that 'spin'.  If you want an idea of what was ACTUALLY discussed then you'll need to check in on this link.

Kindest regards,
Rosie

http://newlightondarkenergy.blogspot.com/2012/01/232-another-summation-based-on.html

[TinselKoala]

Hi Guys,

Just be advised that Glen, like TK - ALWAYS gives insubstantial reference.  It's required for that 'spin'.  If you want an idea of what was ACTUALLY discussed then you'll need to check in on this link.

Kindest regards,
Rosie

http://newlightondarkenergy.blogspot.com/2012/01/232-another-summation-based-on.html

That's pretty funny coming from Ainslie, queen of the NON-referenced and non-supported claims of all sorts. Even when she DOES manage to give a reference to an outside, checkable source, she gets it wrong.
Like the famous Wiki references to power and energy calculations and the definitions of Joule and Watt.

And that entire blog post repeats the EXACT SAME ERROR that has been happening for over ten years now, the failure to understand that DRAIN HI means MOSFET OFF.

Please, watch my last two videos, Ainslie. It is impossible to make the issue more clear than that.