Working SMOT ramp from Tom Ferko ?

[magnetman12003]

Hi Stefan,

Can you tell me where that thread is posted?

Thanks, 

Tom

[Danner]

Tom,

     I saw your Magnet_motor video posted 20 April where you hold the ring above your rotor and pulse it to make the rotor turn.  It seems an obvious question but reading the posts I had not seen it asked so here it is.  Couldn't the pulsing you were doing be replaced by a mechanical oscillator like the one that has it's own link here from the guy... I think his name sounds Russian.  Would combining the two technologies solve the problem? 

Let me know if you have tried anything similar.

Thank you.
Daniel

[magnetman12003]

Hi Daniel,

I used the exact same 10 pound (two magnet) rotor turntable base you saw in my last movie. 

Thats 1/2 of my setup.

The ring you see me pulsing the rotor with did not work out so I discarded that idea.

I made an entirely NEW IDEA simple small stacked neo ring magnet DRIVER DEVICE that centers in the middle of the moving turntable.  I had been reading a lot of Hamels stuff and he seemed to focus on a certain way of doing things   I tried a certain mode of his construction and also added a lot of my own wild ideas I had tried in the past.

Was I surprised when I achieved rotation.  Not a wimpy 360 but continuous rotation.  My only problem now is constructing a small part to keep my fingers from steadying and following the axle shaft.

I may dump all I know into this site after I read more about patenting verses posting all info on the internet.  I need to read that thread first. Unable to locate it.  I just dont want money persons to set up roadblocks to to construct this device. Or start manufacturing it only for a personal profit. 

Its always been my wish to make a working device ( motor) available to all people rich or poor. I am not into this for personal profit. The only moneys I wish out of it is to cover the cost of a 200 pound box in my garage filled to the brim of 30 years worth of failed permanent magnet motor project parts. I purchased them in the past out of my pocket.  Charitys of my choosing recieve any royalties if industry is interested.

If this gets off the ground its inexpensive and very simple to construct.

Tom

[Omnibus]

Here's the thread "Open Source Vs. Patenting":

http://www.overunity.com/index.php/topic,1821.0.html

[TheOne]

don't patent, nobody will able to see what you have done in years!

you cannot show a video about what you have so far?