Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

 
   Personally I don't think that the Kacher circuit should resonate with the 168 turns grenade output coil, as the two are running at totally different frequencies. The 168 coil is not running in the Mhz range, like the Kacher is, nor do I think that it should be, either.

My understanding is that the Tesla bifilar should resonate at the same frequency as the grenade coil (not the Kacher secondary) by correct choice of the series cap. However, I'm not sure what stages the tuning should be done and what coils should be connected / loaded at each stage.  Like you, I am doubtful if anyone on this thread has the full knowledge to write out a clear instruction.

I'm prepared to have another go at building, assuming a comprehensive tuning instruction can be supplied. I think I understand the concept of operation in terms of standing waves but lack the level of theoretical knowledge and practical RF build experience to work out how to tune this contraption. I don't want to waste my time on guesswork.

[NickZ]

   I don't think that that is the way to go, either. 
   I'll show at what frequency the 3 turns coil circuit is running at, now, when using the 0.47 1600v WIMA cap.
   I'll also place a 0.1uf WIMA cap on the 168 turn coil circuit, and then I'll take some scope shots of both circuits, and we can take it from there.

   Hoppy:  Good to hear that you'll get the dust and cobwebs off of the old circuits and coils, and get them fired up again.
That's Great.
   

[Hoppy]

 
   Hoppy:  Good to hear that you'll get the dust and cobwebs off of the old circuits and coils, and get them fired up again.
That's Great.

If we get good comprehensive tuning instructions then I will look at a complete re-build.

[NickZ]

   I wouldn't count on a complete instructional tuning video happening, at least not from one of us. As no one has been able to
obtain any increase in output, over the input source used. To show how it's supposed to work.
But, it would be good to compare notes between the guys that have built up their versions of this device.

  We already have been given the coil winding directions and sizes of the different coils, including the Kacher secondary.  We just may not know how to tune the three different circuits to work together for any "extra energy" to be observed at the bulbs.

[itsu]

  Looks like no one is too sure of what to do exactly, or just how to go about it.
  But, it's not lack of knowledge, as it is a lack of proper instruction.
 
   Personally I don't think that the Kacher circuit should resonate at the same frequency as the 168 turns grenade output coil, as the two are running at totally different frequencies. The 168 coil does not run in the Mhz range, like the Kacher does, nor do I think that it should be, either.

  I'll do some more testing of the frequencies of both of the grenade coils, and compare them to the Kacher frequency to see how it looks.
  I've got my new set of scope probes, and the new WIMA tuning caps, now.  So, I'll install the caps and re-tune things, and report back.

Nick,

i scanned my grenade coil back then for resonance (from 1Khz -> 10MHz) and it had a strong resonance point at 1.29Mhz, see the screenshot and this post here:

http://overunity.com/12736/kapanadze-cousin-dally-free-energy/msg421835/#msg421835

But back then we did not have any capacitor across the grenade (168 Turn) coil.

Regards Itsu