Kapanadze Cousin - DALLY FREE ENERGY

[verpies]

    The aluminum tube may be the reason that only a single bulb is being lit, instead of three as in the akula device. It might be the economy version... as copper is expensive.

Of course.
Also the slot in the pipe is too wide.  It is 5mm now and it should be 0.1mm

[Hoppy]

Hi Hoppy. It might be fake, there is no way to tell for sure.
It wouldn't be hard to hide a smaller sized gel cell in that big coil form tube, for example.
Of course that doesn't mean that this is necessarily what was done however. 

Agreed. Having re-looked more carefully at the white wire under the black coil that I thought could possibly be an 'X'-wire, I can now see that it is in fact just a piece of scrap insulation like several other pieces that can be seen scattered over the demo board. This was a bit too obvious to have been the real 'X' wire, as it would sensibly be brought through totally out of camera view.

@ Nick. I have my big cigar and bottle of vodka ready and am eagerly waiting for the party to start 

[Vortex1]

The most obvious is the long red twisted pair. It seems way too long for the job and may meander down over the edge of the table to a power supply or battery below. (kako chibridze video)

Regarding the akula video, my impression of the back of the chair does not appear to be a twin wire as it too carefully follows the contour curve of what we would expect to see. Besides there are no such wires shown on the top of the board or visible coming out of a hole in the board.

[NickZ]

  Ok Hoppy, we can all party by video, like Wesley was doing with his team. Now that the  team has grown.  The bigger the better.
It's not so easy to stop us now. Is it?   The cats out of the bag... if you believe it , or not.
Now we may have to go look for it...
   I know that this fraud thing will never end, but, I'm about ready to get going on this.  After the cigar, of course.  First things first.  And, if we don't get it the first time around, at least we had a good time.

    As I had mentioned previously, the low voltage part of the circuit is just to give the pulses to the coils, that is NOT where the "secret" lies, as Tinselkoala has also expounded a bit on.
   So, what's left?   Well, we need to look more closely at the relation of how the coils are placed, and in particular on this choke core/coil/cap in the center. Which may also be wound on the same air core, as Romanov's simplified circuit has shown. As this chokes relation has not really been explored, by us at least, except by what a.king had mentioned previously.

  If you first check the Hendershot fuel-less generator, you'll see some very obvious  similarities, that many of us might now understand or can relate to all of this.

  More later, as the pelicans (not the geese), are calling. 
This is my playground... one of them at least. All work and no fun, makes Nick a dull boy...

[Hoppy]

The most obvious is the long red twisted pair. It seems way too long for the job and may meander down over the edge of the table to a power supply or battery below. (kako chibridze video)

Regarding the akula video, my impression of the back of the chair does not appear to be a twin wire as it too carefully follows the contour curve of what we would expect to see. Besides there are no such wires shown on the top of the board or visible coming out of a hole in the board.

The long straggly red wire was the first one I looked at as suspicious but there is a point where he flicks it back from the edge of the demo board and at this point it appears 'clean' and not connected to anything. The 'X' wire could very easily be brought out under the transformer or coil, there is a lot of scope for fakery here as with all video demos where the demo board is not lifted off a table or chair. Again a wire along the seat of the chair is a bit too obvious but it did look a little like a twin wire which is why when I received this clip and given permission to post it, I wanted to see other opinions on it. An elaborate fake like drilling up the chair leg and placing it over a hole in the concrete floor to accept an incoming 'X' wire(s) would be impossible to detect on video unless the chair was lifted and the camera scanned slowly all over underneath, which clearly is not going to ever happen. My problem is that I automatically smell a rat when I see a free running claim, whereas others automatically see the real McCoy. As the saying goes - 'It takes all sorts to make a world'.