Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

  @ anandmll:
   Nice clear picture of the akula device, did you like it? I had sharped it up a bit, also, beforehand. 
  What is inside the big air core is not a yoke, it is choke made with insulated wire over what looks like a pvc pipe. The cap must be small and at the bottom of the choke coil. The choke looks like only a single layer of wire, and so I figure of about 40 to 50 turns, depending on the gauge that was used. I don't really see a full aluminum liner inside the air coil, especially not one with a small gap, but maybe a bigger one of only 80% of the pvc tube size.
  The reason that I really like that circuit, is because it is simple, so simple you'll laugh.  Ha, ha, ha...

[NickZ]

  T-1000:
   I'm NOT the only one building this, I'm possibly just the first one on this thread. You can be the second.  In any case, please, share what you know, and can communicate with Akula, about this project. Also, invite him (again) to come here, or to the sister thread. If he says no way, at least we tried.

   BTW:  There are certainly some interesting things to observe by winding and then pulsing the yokes coil (in the opposing winds, and center tapped way). There lies one of the "secrets".  It won't work with out it.
  I will show more, as I learn the way. I found my misplaced camera to Pc connection cable. I'm in like Flynn. I can now promise to show and tell anything worth while.

[verpies]

Don't piss him off, send him some chocolates, etz...
Контактный Email:   akula0083@mail.ru 
Мобильный телефон:   +77074476271 
Домашний телефон:   +77776726587 
Skype:   akula0083 

A Russian speaking person should talk to him.  I don't qualify as such.

[NickZ]

  There are several of us (not me, either) that can talk to him, e-mail him, or Skype him online when available, for free.
  I use "Voxer"  from the goggle play apps.  If you espeak spnanish.  Just kidding...

[Grumage]

P.S.> Why there is only one doing and hundreds speculating? That is leading to single point of failure and is disencouraging me to share anything more... Itsu, verpies, it is worth to try and I personally could help with experiment on skype.
[/quote]

Dear T-1000.

I am more than willing to take up your offer. But only on the basis that your input and any progress made be shared openly between the two theads.

I have a modest budget available and am ready to start at once. I am also willing to share my Skype address via PM.

I am based in the UK and have a large mechanical engineering workshop at the back of my house. I am an enthusiastic individual and I do not think there was none more disappointed than I with the failure of the Chibinidze device.

With that stated, if you are willing to help? Please post the schematic that is the starting point for this project.

Cheers Grum.