Kapanadze Cousin - DALLY FREE ENERGY

[Void]

And yes I did buy an Induction cooker hob. But unfortunately it has some sort of detection circuit and does not see my coil placed upon it. So it just pulses and then locks out. Never mind I suppose I can use it to cook on

The induction cooker protection circuitry switches off the output if the induction cooker is not seeing a proper load.
You have to have the right amount of load connected to your output coil and then it will stay on. For example, if the load
resistance/impedance is too low, the output will turn off. I experimented with light bulbs as a load and found that if I had enough light bulbs in series to give around at least 50 ohms resistance or so , the induction cooker would stay on. Likewise a load with too much resistance might cause the induction cooker to turn off as well as the protection circuitry will see it as no load.

[hartiberlin]

Hi All,
I am back from vacations
and now I fixed the page 126 and 129 display problem of this thread.

It was about posting a 4000x3000 pixel picture.

Please scale the pictures down to about 1024x768
or smaller, before posting them.

I will soon move to a different forum software and than these problems will
hopefully be over.
I could also switch off the display of the images under the posts and only have
a link to save the pictures...
But I would rather keep it like it is now, as this shows immediately the
posted picture in a nice format.

If somebody will willingly post these big pictures to interrupt the forum,
he will be banned from posting from now on...

Many thanks for your cooperation.

P.S. You don´t crash the server, the posted pictures are still there, but the display PHP script is just
not able to show it this way. so no worry about the content.
I just rescaled the attached pictures to a more friendly 1024x768 format, that was all...


Regards, Stefan. ( admin)

P.S: I hope you guys are coming forward and will show and publish a real
selfrunning Kapanadze device soon.
Great progress so far ! Let´s keep it coming !
Many thanks.

[verpies]

Polythene dilectric @ 0.085 thick. Formed into a cylinder of 95mm Dia.

Do you mean Polyethylene ?

[Grumage]

Do you mean Polyethylene ?

Dear Verpies.

Thank you for your response to my question. I have now re made my capacitor plates. I tried using the thin sheet used for the Lithographic printing process but no matter how I tried I could not get it to hold a tubular form!!

The new plates are formed from standard grade 1 mm thick Aluminium and I have used an " oven roasting bag" as the dielectric material. This was recommended to me many years ago by my old electronics tutor!!

So my dilectric is now a form of high temperature Nylon. And has boosted my capacitance to 5 nF. I may be able to further increase by putting some internal ring braces to improve the contact area.

Cheers Grum.

[Void]

You're quite welcome Grum.