Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

NickZ have a look at the output of your yoke whats the waveform like?

AG: The TL494 driver and mosfet circuit produces square waves to the push pull circuit and the yoke. Both my 3t and 28t coil are running at the same frequency. And that frequency does not change when the Kacher is also turned on. The output at the yoke by itself, without being connected to anything, is about 1000v, with no load. The output at the grenade's output coil after the rectifier and full diode bridge is only about 60v to 80v or so, depending on the load. The TL494 controlable driver circuit and the induction circuits are working as they should.
   Here's an older picture, below, 3 200w bulbs, running on just 18v.

[NickZ]

Nick Z


Listen Nick is Equidor by your neck of the woods? Here is your chance to help someone out as you might speak his or he lingo Spanish?  only he/she is not too good with English can I put them on to you? tell them they will need a scope a signal generator an inductance meter etc

   No, please don't put them on me. You can tell them how to use the translator in google.   Thanks.

[NickZ]

   Jeg:   You've probably seen the video where this diagram was shown, but I thought I'd post it here, anyway.   Not sure if it was originally from Roma, or drawn by someone else.
   

[AlienGrey]

The yoke and the 28 turn winding should be a sine wave at its resonance see cap across the 28t winding ie 37.5 m or 40m, not a square wave
see schematic and scope shot of yoke and Katcher collector.
Now you know So be care full how you find the correct value don't get blowing anything up!

[NickZ]

   That's right, the yoke's output as well as the grenade output, are sine waves, but it starts as square waves from the fets.
But, the diagram that you just posted is not how I have my device connected up. Nor do I use a controlable Kacher circuit, as yet.
   I have tried many different types of connection methods, to see what works for me.
   You may want to watch some of my videos, if interested, to get a better idea of what I've already done.
   The wave form below is what I'm opting for in the future. Once using the controlable Kacher as Stalker has shown.
   My current Kacher circuit is just like the one shown and replicated from the TopRuslan 7 video, below.
   Now I know what?  I just love to blow shit up, and getting good at it.