Kapanadze Cousin - DALLY FREE ENERGY

[Jeg]

As you say Jeg, it really doesn't matter which way we individually proceed. Diversity is the spice of life. 

When i started this project before some few months, my intentions was to replicate the effect, and understand the nature of this so to repeat it in a controlled environment. During these months, i gave all myself to this research. I have tested all possible connections with the most basics. Just a yoke, a kacher driver, two tuned coils and that is all. I have tested 4 different yoke configurations, i have changed 5 times my grenade, and i have wind more than 6 different inductors in terms of form, turns and wavelengths. The earned experience is something that can not be described. But the most important.. i met you guys! This is something even more important than the project itself. And i think it is the right moment to say a big thanks to you all. So many researchers on this thread, so many nice fellows that deliberately share their ideas and efforts. I still don't have a self runner but i already feel like a winner. About assumptions and no-purposely misleading, what can i say. Everything is needed. It is better to fail while trying than not trying at all.








 

[itsu]

The longer Tesla coil is OK as long as it can run on required frequency.
Does CFL light up on almost full brightness like in http://youtu.be/KlXM2nYtbus?t=5m35s ?

Hi T,  i don't know, i have not tried it yet, i will tune (add more wire)  this Kacher secondary so it resonates at my grenade coil
frequency of 1.685MHz first.

Regards Itsu

[itsu]

Nick and Jeg,

nice and uplifting words, i could not agree more with both of you guys,  thanks.

Regards Itsu

[itsu]

Still confused, i am
Hi to every one including our Russian friends, Ukraine, Australia and where ever you are, hello. Can we just for a moment please focus on the coils on the 50mm PVC tube. If we look at the grenade coil (37.5meters long) altogether 48+48+24+24+12+12 = 168 turns of wire, ok up to here with that  now ontop of that we add 52 so how does that = ½ the wave or ¼, if it's half wave that's 37.5meters / 2 = 18.75 meters, (so how does that add up ?) and on top of all that we have a thick white cable any one any idea what wave length that's tuned to ? it has to be a multiple division of the 37.5 meters for a harmonic (multiple) to sit in. Now we have the transmitting Katcher coil any one any idea the wave length of that, that also has to have a fixed tuned wave length, again what's it's wave length ? and for any gain don't we have to have our windings going in the same direction the earth travels in space, it's spin ?

Feel free to add any comments, but the sooner we get this idea working the better for every one who needs alternative energy.

Hi AG,

focussing on the "coils on the 50mm PVC tube" (guess you mean the Grenade, its bifilar inductor and the antenna around it),
indeed we have 168 turns (48+48+24+24+12+12) for the base Grenade.

The bifilar inductor (so wound differently as the Grenade), has, to my knowledge, NO fixed number of turns (you mention 52).
In severall publications it suppose to be ½ the wave of the Grenade or 37.5meters / 2 = 18.75 meters, but this simple does NOT
fit the space available on the lower end of the Grenade (about 10cm) if wound in 2 layers.
I needed 3 layers (each 27 turns) to have it fit.

It more likely is 2 layers (each 27 turns) which in my case ends up to about 13 meters, but this has no wavelength relationship
to the 37.5m of the Grenade as far as i can see.

The antenna around the Grenade/bifilar inductor is just that, an antenna, it suppose the transmit or induce the electric field of the
Kacher to the grenade/bifilar inductor.

The Kacher, in my idea, is to be tuned to the resonance frequency of the "Grenade/bifilar inductor/ground" which in my case seems to be
1.685MHz (which is a wavelength of 178m)

My next steps are to tune the new (spaced turns) Kacher secondary to the 1.685MHz resonance frequency of the Grenade/inductor/ground combo,
then tune/trim the bifilar inductor to some resonance at this same 1,685MHz frequency (so 1/2, 1/3 or 1/4 wavelength of the
1/4 of 178m    meaning 22m, 14.8m or 11.125m with the latest the most promising).

It might be that trimming the bifilar inductor influences the resonance frequency of the grenade too, so fine tuning could be needed.

Finally there might be what is being mentioned by severall people, NO LC resonance in play here but standing wave resonances like mentioned by
Enjoykin earlier here:
http://www.overunity.com/12736/kapanadze-cousin-dally-free-energy/msg423561/#msg423561

we don't use here LC resonance but Scalar resonance which strictly depend from Q-factor of coils, depend from standing waves and unknown us interaction standing waves with
ambient

I tried to use my pico pulser to "probe" the bifilar coil, but could not detect any reflections coming back from it, but probably need to redefine this
"time domain reflection" method somewhat for using on a coil.   

Hope this helps   


Regards itsu

[NickZ]

  Although I don't fully understand just what the Scalar Waves are, which are also providing for the standing waves. But, I'm willing to learn more about it.
As I also feel that there is an important relation with our devices.
 
  Although we are using normal electronics components, to achieve some results, their effects may not be the same or even similar to what normal electronics theory is all about. 
  I do feel that the Scaler wave length idea is worth considering, as well as the standing waves, that provide a pathway and allow for the transmitting of other waves within it's frequency.

  The tuning of the these devices reminds me of how a normal car engine also needs to be tuned to provide for the spark at the precise moment. Without which even the best built motor would not function properly.