Kapanadze Cousin - DALLY FREE ENERGY

[MenofFather]

   Pic posted on main TK forum too and now its gone as well. Hmmmm?

Guess that points to something there that wasn't wanted to know.

thay

That adress of you TK forum?

[MenofFather]

  MenofFather:
   I don't know about the choke connection, other than it just goes a tuning cap. But, in the Hendershot information, the coil/capacitor in the center of the big air coil goes to a iron core transformer that is located outside of the air core. Maybe the choke on the akula device also goes to one of the air coils, or maybe even to the yoke through the white wire that is under the choke. Hard to say what is going on. I think that the only way to find out is by testing the results.  I just don't want to connect 110v DC to the yoke direct, yet, but I may give the yoke primary center tap 30 to 50 volts AC to see what happens.  I also will probably hook up my CFL bulb driver circuit to the yoke to see what it does. It should output about 250v volts, or higher.  Any way, that's what I have in mind to do next.

I speak about other choke in previous my messayge , who conected to center tap of yoke. This choke is on driver borad, so looks that center wire gose to driver board. But this is not important, not use big atenshion to this message. Чтоб не перезагрузить людей не важной информацией и они не внимут важной.

[anandml]

@OVERUNITY FORUM ADMINISTRATOR
Kapanadze Cousin - DALLY FREE ENERGY Webpage 126 is showing a blank page or disappeared from dally free energy forum.  Please solve this problem... 

[a.king21]

Was this on page 126?

[Thaelin]

That adress of you TK forum?

I  am refering to the main one on here as well on Overunity.com. It was there just a short time then gone as well.

thay

Also: I will say it again now. I seriously cannot see how you would want to put that much voltage into that small a winding of such large gauge. That is simply a hard short and will blow up the converter or if protected, simply shut it down. I admit that high freq can do strange things when applied to coils due to the impedance factor but not at 100hz.