Kapanadze Cousin - DALLY FREE ENERGY

[Jeg]

What do you say about that? As you see changing diodes is an easy task. I just wonder about what starcruser said  for the filters.

[NickZ]

  Magpwr:
  The diagram above was made by Akula, for his second video device.  But, the picture of the crt is Ruslans.

  Hoppy, ok I'll check a few things and report back.  I've always had the fets heating up on me, on the previous Mazilli, as well as this one. Even when lighting only a single 100w bulb. This makes it so that I can't turn on the device for over a minute or so. I'll connect up the rest of the air coils and tuning caps to the yoke circuit soon.

[magpwr]

What do you say about that? As you see changing diodes is an easy task. I just wonder about what starcruser said  for the filters.

hi Jeg,

Once the filter section is removed connecting to 110volts or 220volts mains may be risky as the sudden in rush of current may kill the device.

Unless you have auto transformer to slowly raise voltage from the lowest settings  or connecting to Yoke or a large toroid core which is still considered better choice than mains.

[magpwr]

  Magpwr:
  The diagram above was made by Akula, for his second video device.  But, the picture of the crt is Ruslans.

  Hoppy, ok I'll check a few things and report back.  I've always had the fets heating up on me, on the previous Mazilli, as well as this one. Even when lighting only a single 100w bulb. This makes it so that I can't turn on the device for over a minute or so. I'll connect up the rest of the air coils and tuning caps to the yoke circuit soon.

hi Nickz,

I am not sure if you are keen on monitoring frequency or duty cycle which i can recommend this multimeter Genuine UNI-T UT136B Auto Range Digital Multimeter AC DC.  Ebay Seller :spctech-p
This is <$20 USD gadget and comes with free shipment.
This is after doing some basic research from some multimeter freaks in youtube.

I have recently obtained this multimeter to compliment my scope.I am very impress for this price it can measure frequency of sinewave/square wave with great accuracy.
The best part it can even detect ultra low 0.1% duty cycle.

------------------
Tomorrow i shall wind a tesla coil.

[Jeg]

hi Jeg,

Once the filter section is removed connecting to 110volts or 220volts mains may be risky as the sudden in rush of current may kill the device.

Unless you have auto transformer to slowly raise voltage from the lowest settings  or connecting to Yoke or a large toroid core which is still considered better choice than mains.

Thanks Mag. I am between diode modification and 24V output modulation to 50Hz. We 'll see..