Kapanadze Cousin - DALLY FREE ENERGY

[MenofFather]

Pulses seems is on curent transformer secondary.
Here test of one man http://realstrannik.ru/media/kunena/attachments/5741/Izmerenie_1.JPG

[Grumage]

Dear all.

I have been making the most of the decent weather pursuing other avenues of OU whilst quietly looking in from time to time here.

Perhaps this short video may shed some light on earth ground issues, you decide ??

https://www.youtube.com/watch?v=RDDfkKEa2ls

Keep up with the great work you are doing !!

Best wishes to you all, Cheers Grum.

[itsu]

Pulses seems is on curent transformer secondary.
Here test of one man http://realstrannik.ru/media/kunena/attachments/5741/Izmerenie_1.JPG

MenofFather, thanks, very nice, i have re-shown this picture below, see screenshot 1.

I tried the same setup but using my current probe instead of the current transformer, but i do not get these current spikes, see screenshot 2.
So my idea is that the used current transformer toroid is getting saturated giving these spike like signals.
I have a nice sine wave current signal with the probe controller set to 5A/div. so there is lots of current running in that circuit.

By the way, i grounded my Kacher return lead, and it caused the HV signal to be reduced a lot, still visible, but much less.


Regards Itsu

[John.K1]

Guys,

Maybe it was here already, but never mind. Just listening Ruslan's Skype conversation and with my poor Russian I catched this information:

The frequency of small induction coil ( TV choke) must not oversize 10th harmonic. In his case 20KHz . 20KHz has to be signal generator. Than you will get sharp edges."

Cheers

[magpwr]

MenofFather, thanks, very nice, i have re-shown this picture below, see screenshot 1.

I tried the same setup but using my current probe instead of the current transformer, but i do not get these current spikes, see screenshot 2.
So my idea is that the used current transformer toroid is getting saturated giving these spike like signals.
I have a nice sine wave current signal with the probe controller set to 5A/div. so there is lots of current running in that circuit.

By the way, i grounded my Kacher return lead, and it caused the HV signal to be reduced a lot, still visible, but much less.


Regards Itsu

hi itsu,

This is a long short or unconfirmed theory of mine at the moment as mentioned below-

Maybe the toroid coupled together with diac or sidac may get below 500ns pulse.

I realized tvs diode would produce flat top at the peaks.so this diode is out of thr question.