Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

 
  The new red WIMA 0.47uf tuning capacitor on the 3 turns coil is 4 times the size of the previous yellow 275v 0.47uf capacitor that was on there before, (image below). So, I'm looking for those big angry sparks, when shorting it out. But, I'll need to remove some turns on my Kacher, first, as its frequency is now just a bit too high and the 1mm streamers are weak, at 2.5Mhz.
I'll probably need to go to down to about 2.4Mhz on my Kacher's secondary coil frequency, to see if there is any improvement there.

You may need to up the Kacher primary voltage to get the angry sparks.

[NickZ]

    Guys:
   Here's an Akula video, explaining the tuning relationship between the various circuits on his 2nd video device, along with the showing the right schematic, (his schematic), of the same device.
    Seams like what both Itsu and T-1000 have mentioned is right. Concerning the procedure to go about tuning the various circuit.
   I wish that I could understand the video, as it looks very important.  This is where our Russian speaking members can help.
   It would be good if MenofFather was still hanging around here. Maybe he'll also take another whack at it this device. 
  I didn't mention GeoFusion, as he may be too involved with hydrogen and cars, to keep going on this. 
  Come on,  Geo... quit dragging your butt...
 
   I'm also seeing very similar wave forms, as the ones Akula is showing in the video. And my scope is also showing me just where on each coil the amplitude output is highest. By moving the probe just along the coil turns. This method can be used to further tune each coil to it's best output, and further re-adjusted using tuning caps.

   https://www.youtube.com/watch?v=fp3sed_eli0

[John.K1]

This is the video Ruslan was saying- "don't do it this way" -no need to do it this way   

In brief, what Acula says is : first you have to find the resonant frequency of your grounded coil. The type of cable used has small effect on this frequency too (he was using previously Litz wire and his resonant frequency was lower (by 100KHz)  His grounded resonant point was around 5MHz which is too far to use it. So he was looking for lower harmonic and he decided to go with 1.8MHz . So he must get Tesla to work on this frequency and also tune the coil/Capacitor  for this frequency (9:50)
Than, he tunes the  LF harmonic to his  LC circuit  (11:25)  17-32 KHz -your choice (he used 32KHz)

Important moment is to hammer our coil/capacitor (atoms in our wire) with shap positive pulses. That's why he has the inductor between the Tesla and Antenna. The induction sharpens he front face of the amplitude resulting in ns hammer impulse  (    ) 

That's roughly all   Good luck with that.

[verpies]

The type of cable used has small effect on this frequency too (he was using previously Litz wire and his resonant frequency was lower (by 100KHz)

Yes, the Litz cable does not affect the self resonant frequency of a coil much ...BUT it does affect the Q of the coil a lot.
The cable insulation and turn spacing affect the coil's self resonant frequency very much.

[forest]

Your main mistake is the searching for HOW IS IT DONE. You must understand WHY IT IS DONE THAT WAY.
The sweet spot need careful adjustment and every circuit is different. You cannot replicate something you don't understand how to tune and WHY. Of course I'm talking theoretically.