Kapanadze Cousin - DALLY FREE ENERGY

[Jeg]

Hi guys
I tried yesterday to wind my yoke according to Verpies circuit design. (Loseless clamp)
Unfortunately yoke doesn't have enough space to wind properly 4 primaries with 2,5mm2 cable. So i go with acula snubber again but designed properly this time by the help of Itsu's link.
(https://www.maximintegrated.com/en/app-notes/index.mvp/id/3835)
I hope today i'll make some first tests with my new board.

I see this new Sergey's design and looks quite interesting. Does anyone know how does this reley work? I mean where are those X13, X14 entry points?

In addition. I'd like to supply my 12Vdc fans for my mosfet's cooling. Do you think if an lm7812 is enough for both of them or is it better to connect them in series and feed them by my 24V pwr supply?

[Hoppy]

     
    As it seams that URFA has given up on the project, and there's no news or confirmation of a self runner from Sergey, it may be up to you to continue on with all this. More than one of us would jump in, even Hoppy, should you show something interesting.

That's possible Nick assuming that Geo starts some serious measuring to show if there really is anything interesting going on. Just flashing lamps at various brightness levels does not cut it.

[Jeg]

Just flashing lamps at various brightness levels does not cut it.

Itsu's black box is the answer on how to measure bulb's brightness and device's efficiency. It is in my diy list!

[Grumage]

Itsu's black box is the answer on how to measure bulb's brightness and device's efficiency. It is in my diy list!

Hello Jeg.

Here was my solution to measure " true " device output.  It cost very little to make and was also easy to calibrate using a wattmeter. I used a 60 W 240 lamp contained within a candy tin. The PV cell was from a Pound/Dollar store garden light. In fact the most expensive part was the micro ammeter at £5.00. I calibrated the meter using a small potentiometer in series with the PV cell.

I have attached a link to my replication attempt for those that might be newer to this thread. What I find odd is that all the videos I have watched show little sign of interference from the running device. My video was the second attempt, the first time all video froze up, the second attempt also froze the last 20 seconds or so, leaving just the audio!!

My " Tesla style coil " was placed within the main coil and was using parallel plate Aluminium split tubes with a dielectric directly connected to the 650 turn coil.

https://www.youtube.com/watch?v=LOqjTHmmumU

I gave up after the very expensive IGBT " blow outs " got too many and painful for the back pocket !! 

Cheers Grum.

[NickZ]

  Even just placing a grid powered bulb next to the device powered bulbs is enough for me.  What's the use of measurements and readings if the device can't self run.