Kapanadze Cousin - DALLY FREE ENERGY

[verpies]

What do you mean by "to parallel low-count windings"?

That's why I wrote, that this is difficult to describe in words without a drawing.

Below is a schematic of 1-turn distributed winding that could be spanning the entire circumference of a toroidal core.

[verpies]

...what about the secondary? Doesn't it need too to be wounded with the same manner so to have Lenz?

The same rules apply to secondary windings if the transformer needs to have a low leakage inductance and a high coupling coefficient (k) to minimize ringing and losses.

Can we safely assume that case 3 is better than case 2 when diameter of the core is higher than a critical value? Or case 2 is better than case 3 in any way?

The latter.
The ratio of toroidal to circumferential ampturns will almost always be in favor of the former.

[verpies]

In regards to   values of the resonance  circuit that would never be seen as capacitance  and inductance.
You must think of it as components of impedance at given frequency.
In the Smith chart you can easily calculate- see( with no calculation) the values of impedance.
...
4. instrument that uses Smith chart is Vector Network Analyzer (VNE) or  Network Analyzer (NE)

You're right but you and I are probably the only ones on this forum that have the VNA.

Not many people here even have a Scalar Spectrum Analyzer (which are blind to phase relationships) and I don't even know if Itsu's analyzer has a tracking generator.

[Jeg]

Thanks Verpies!
I don't know when this replication can be considered as finished, but for sure we have learned how to make a decent push pull transformer for any occasion.

[T-1000]

Thanks Verpies!
I don't know when this replication can be considered as finished, but for sure we have learned how to make a decent push pull transformer for any occasion.

Yes, it took fair amount of pages just on the simple circuit. Now the Tesla coil driver + PLL push-pull awaits your effort...