Kapanadze Cousin - DALLY FREE ENERGY

[AlienGrey]

  Wow, lots of ideas. But, where are the replications to prove a point of view, or what you've observed,  that works?
   
   Concerning tuning, it's not enough just to make the Kacher's output (30w input, or so) add to the brightness of the bulb(s).
We've seen that done by several guys now, and it still not not even OU, and much less self running. 
  We've even seen guys tune their devices right to what is supposed to be the exact right frequencies, and nothing, no added gain.  So, what's up with that???
  I've been waiting for Geo or any one else, for that matter, to get their rid running and show us how all that syncronization, from the mediator, PLL phase lock, and all those various other controls can produce a self runner.  That's what is needed.
  But so far,  no cigar.

  I'm still working on the premise that those things mentioned above are not needed. As Roma has shown, on his last video.
  Still,  the proof is in the pudding...

Nick you sound totally disillusioned and pissed off, did you not watch Geo's video ?

[NickZ]

  Yes, I watched Geo's last video. He is still powering his induction circuit from a 24v, 15A PS. As well as the Kacher. To light one or two bulbs partially, from the 360w PS.  His secondary PS is lighting the bulbs very low, as can be expected using only the 24v output. The watt meter is not accurate, or not connected to both induction and Kacher circuits.
   I'll wait for his next video showing the completed feed back loop, and what that can do.  In any case, it all seams like a step in the right direction.
   If I sound pissed off, it's only at myself.
   

[AlienGrey]

This might be of interest to anyone building the Sergey card, as the current Nand can't successfully drive the Mosfet driver as is and two unused gates would be needed to correct the problem.

[T-1000]

This might be of interest to anyone building the Sergey card, as the current Nand can't successfully drive the Mosfet driver as is and two unused gates would be needed to correct the problem.

Just sometimes making "proper" connections there might be what is killing sync effect. Geofusion even had to unsolder some capacitors near driver chip when he tried different board...
Obviously that is grey area for research until correct combination is found.

[MenofFather]

If you need translation, I translate this part.