Kapanadze Cousin - DALLY FREE ENERGY

[verpies]

Does anyone know why the diode in the schematic shown below seems to be reversed the one near the drain of K2611 tesla driver.

If K2611 is an N-ch MOSFET then it doesn't make sense unless it is a diode that is meant to conduct in reverse such as a transil, transorb, Zener, etc...

[conico]

The first time I saw more light when I powered Katcher.
resonance frequency of 14 Khz was but when I started Kather frequency doubled to 28 Khz
Tesla coil is not yet in tune with Grenade coil must decrease frequency 90-100 Khz to be in resonance.
Two bulbs of 100w 230v to each give about 50% light and are fitted after the rectifier bridge.
  Geofusion Thanks, you inspired me.

[Hoppy]

   
   Hoppy, I did not say that there was something unusual or unconventional to these circuits, as we have them, now.

Thanks for your clarification on this point Nick.

You ask: "It's interesting to note, that Geo's lights don't change now, when he shows the Kacher's output streaming to a metal object, as it did previously. Nor does it kill the output at the bulbs as it used to do. Why is that so, now?"

I suspect that the alteration to his output circuit from V1 to V3 and positioning of earth wire is damping much of the HV that was affecting the operation of his his push-pull. The fairly stable frequency that you have observed may be an indication of this.

[verpies]

resonance frequency of 14 Khz was but when I started Kather frequency doubled to 28 Khz

Is there any difference if you just set your push-pull driver to 28kHz without the Kacher?

[conico]

I did it and the signal from serial cap with 3 turns is small, the resonance of inductor is at 14Khz, so, nothing on 28 Khz.
First of all i must add some wire to secondary of Tesla coil to be in resonance with Grenade.