Kapanadze Cousin - DALLY FREE ENERGY

[conico]

I have not heard about electrostatic field in Ruslan devices, maybe it was someone assumption, supposition!!
Ruslan or Akula didn't speak about electrostatic field.

[Dog-One]

Unconventional...?

Like when you see Russian schematics where the coils are non-terminating and being used as capacitor plates instead of coils?

That kind of weird stuff you never find in typical electronic componentry?


I usually pay close attention to that sort of thing, because I have no textbooks that describe it's operation or intended purpose.  What's worse, when I build those sorts of devices, I'm not even sure how to test them.  But I do know now to look for parametric oscillations--setting up the conditions for them to manifest is still a little mind boggling.

[lost_bro]

Good day All:

In relation to this video:  https://www.youtube.com/watch?v=ZTOrWiQ1rJ4

I have posted a couple of screen shots.

First;  Can anyone tell me what the second TO-247 device is on the Karcher Aluminum Heatsink. I would assume that ONE of the TO-247 devices is the Karcher Transistor.  OK, what is the second? 

My guess is that this is the DIODE that runs to *ground* from the base of the secondary (Karcher).

Second;  Please note the couplings that Ruslan used on ALL the connections to his -coils-. 

Does anyone realize implications of these connectors?

If you want to *terminate* a coil at a certain wavelength in order to tune it to a certain frequency, the wave traveling inside/around the wire of that coil must interact with a certain condition. That condition is usually known as a termination.
The termination is the *electrical* end of the line so to speak.

Those -BIG- terminal blocks are not just eye candy...........  Because of the impedance change brought about by a *drastic* change of transmission line/wire size, the wave traveling down that coil will now react with that change of impedance and terminate/bounce/radiate accordingly. This effectively defines the *electrical* length of the coil and as such it's *L* and Fres.

I am willing to bet, that those coils are precisely measured and cut to a calculated wavelength and those terminations permit exactly for that to occur. Just food for thought.

Well, it's not my design so I could be wrong

take care, peace
lost_bro

[conico]

Look for diagram ''Topruslan 8'' is a mosfet for supply Kacher or in Topruslan 8A is a mosfet near 2SC5200 for drive it.
About terminals of the coils ,there is no problem. If Ruslan establish the resonance with this long terminals he must keep them not cut the terminals.

[boonk]

Hi,
Yesterday, I give  on one Russian forum
- They spat at me!..