Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

  Verpies: After some more testing, I can see that both fets are ON at the same time.
   What can be done about it?  If I go back to your suggested connection method, I'll only have one channel working. And even that one channel may not be working right.

   AG: the frequency is high, barely able to hear it. Don't
know exactly at what frequency until I do the math on it.
But,  it doesn't matter until it's working right.

[verpies]

Verpies: After some more testing, I can see that both fets are ON at the same time.

What voltage do you have between pin13 and pin7 ?

[NickZ]

What voltage do you have between pin13 and pin7 ?

  As it is right now, my multi-meter can't read the voltage between pin #13 and pin #7. Possibly due to high voltage interference  from the kacher. It should read 12v, though. Maybe if I disconnect the kacher
   I'll keep looking into the problem tommorow, as it's getting late here tonight. 
   I was getting the same signal as I had shown at first, out of the TL494 and out of both drivers. Which I checked just beforel I added the snubbers, and connected the push pull up to the yoke and to the rest of the system.
   

[verpies]

It should read 12v, though.

No, it should read 5V

[TinselKoala]

Some scope shots would really help to diagnose the problem. Even from a blurry scope.

Both mosfets should not be turning on at the same time. If the 494 is producing complimentary outputs from pins 9 and 10 with some dead time as it should be doing, then there must be something wrong downstream.