Proof of Overunity From Magnets Fixture, No Negative Work Aspect, LaFonte

gammarayburst · October 19, 2013, 08:53:55 PM

Quote from: Floor on October 09, 2013, 02:15:29 PM
@GammaRayBurst

I have a question, that I am not sure if you know the answer to or not.

Please see the attached file "PsuSol3.JPEG" drawings and question.

Cheers
floor

Floor, Yes I would think so. The magnets without the plates for sure would want to so I think they would want to with the plates attached.
Butch

gammarayburst · October 19, 2013, 08:57:33 PM

See attached

gammarayburst · October 19, 2013, 09:04:55 PM

Note that section A and B could be just two separate plate sets of any length and do not have to be divided into smaller sections as shown.
[size=78%]Thanks,[/size]
Butch LaFonte

gammarayburst · October 19, 2013, 09:55:58 PM

See attached

gammarayburst · October 19, 2013, 10:04:19 PM

Quote from: gammarayburst on October 19, 2013, 08:53:55 PM
Floor, Yes I would think so. The magnets without the plates for sure would want to so I think they would want to with the plates attached.
Butch

Floor, I think the plate set would rotate if hinged in the middle but would stop when set went from repulsion to attraction mode. I am thinking that would vary with the geometry of the plate. I doubt it would do a total 180 degree flip. Maybe more like 45 degrees?
Butch LaFonte