Work from two magnets > 19 % output

[Floor]

OK
lets start the debate



                         Floor

[TinselKoala]

"with a spacing of 22.4282 mm between them."

That's where I stopped reading. Please demonstrate your ability to position magnets with a precision of 1/10000 mm.

[TechStuf]

TK must have skipped his geritol today....

http://www.ebay.com/itm/SCHERR-TUMICO-OD-1-2-Micrometer-1-10-000th-Inch-Accuracy-Free-Ship-0300-/221305099050

It's just a measurement reading.  No exact significance was placed on the figure by anyone but you, TK.

Push your glasses up off the end of your nose, take a deep breath and read on.....(moot inquiry alert).....You are still capable of being educated, are you not?


TS

[TinselKoala]

TK must have skipped his geritol today....

http://www.ebay.com/itm/SCHERR-TUMICO-OD-1-2-Micrometer-1-10-000th-Inch-Accuracy-Free-Ship-0300-/221305099050

It's just a measurement reading.  No exact significance was placed on the figure by anyone but you, TK.

Push your glasses up off the end of your nose, take a deep breath and read on.....(moot inquiry alert).....You are still capable of being educated, are you not?


TS

Hey, TS... can't you tell the difference between an INCH and a MILLIMETER? I have micrometer calipers that measure to the tenthousandth of an INCH myself and I know how to use them. A ten-thousandth of a MILLIMETER is quite a bit smaller than that, since there are 25.4 millimeters to the inch.

"No exact significance was placed on the figure by anyone but you, TK."

Er... nope, someone put that exact figure into the PDF and, by implication, asked me to believe it. But I can't, without some evidence that the person citing the value can actually make measurements of magnet position to that precision and accuracy. Just a measurement thing... well, I can recall a  certain very expensive spacecraft that missed its target, Mars, completely because of a "measurement thing". Measurements and accuracy are important, and false precision is just that: false.

And I learn something every day. Don't you? Good grief, what if Overunity actually needs 22.4283 mm spacing instead of 22.4282 mm?

[TechStuf]

You've made my point!  Your anal retentiveness precludes learning opportunities because you are JADED.  So jaded in fact, that you really seem to believe that a measurement unit mistake of 1/10,000th of an inch vs. 1/10,000th of a millimeter on a wooden model could be an overunity deal breaker.  Of course you didn't even make it far enough to see the model, or investigate the concept as you abandoned the story with prejudice well beforehand.  Of course that's what you get for popping your head in to a topic merely to make sure it still rattles.

Tsk, tsk...

How unscientific.....or should I have said, how very establishment scientific of you...

The Hubble telescope supposedly went up with a costly unit measurement communication mistake.  With you pioneering the team, it wouldn't have gone up at all. 






TS