Partnered Output Coils - Free Energy

[EMJunkie]

It is clearly shown in Tinman's schematic that Coil A and Coil B are not "paralleled up".

You are apparently intent on seeing what YOU want to see, not what is drawn.

Youre just stupid!

Tinman said he used a: IRF540

What's going to happen to the Cap: If Coil B was Shorted?

[EMJunkie]

Youre just stupid!

Tinman said he used a: IRF540

What's going to happen to the Cap: If Coil B was Shorted?

Regardless of "Shorting" - Whats Going to happen to the Cap with one Polarity of an AC Signal across the Cap? Whats the Diode in the Fett going to do to the Cap depending on its Polarity?

[picowatt]

Youre just stupid!

Tinman said he used a: IRF540

What's going to happen to the Cap: If Coil B was Shorted?

Really?

If you knew a bit more about electronics, and were paying more attention to what Tinman has posted, you would have a pretty good idea of just how he has that MOSFET connected.

Personally, my hat is off to him for the elegance of the circuit configuration he chose to short his coil.

Again, Tinman shorts that coil, at no time is it connected in parallel with the other coil or with the output cap as you depicted.

That is what his schematic depicts and that is what he has said on his videos.

[EMJunkie]

Regardless of "Shorting" - Whats Going to happen to the Cap with one Polarity of an AC Signal across the Cap? Whats the Diode in the Fett going to do to the Cap depending on its Polarity?

How is a DC Electrolytic Cap going to possible charge under these Circumstances?

Are you stupid Picowizzard?

[picowatt]

How is a DC Electrolytic Cap going to possible charge under these Circumstances?

Are you stupid Picowizzard?

Under what circumstances?  He is shorting the coil B, not the output cap.

Try spending more effort understanding the schematic and less on dreaming up insults...