Partnered Output Coils - Free Energy

[Vortex1]

Almost 6000 posts to this thread in over 400 pages. Wonder who will be the lucky #6000 and if there is a prize?

Surely Stefan should kick back some small token, perhaps just a kazoo for keeping the hit meter in spin.

[Pirate88179]

Almost 6000 posts to this thread. Wonder who will be the lucky #6000 and if there is a prize?

Yes, the prize is that you get a visit from the MIB.

Bill

[tinman]

 author=MileHigh link=topic=15395.msg464253#msg464253 date=1445989488]


Ok,well i will try again,as i dont like putting all my eggs in one basket,and leaving those here !that were interested in what i have! hanging.
I will continue to provide and post results here-as long as what i believe is not dismissed by those that !think! we know all there is to know. If some one can tell me exactly what the magnetic force actually is,then i will take what you have to say as gospel,but until then my thoughts will be mine until i decide otherwise.

I am also up for carrying out test that others might like to see done--but be specific on the parameters.

Brad molded a funky dual coaxial toroid, with one inside the other.  It's an unusual magnetic circuit, and so far we have no evidence one way or the other if it does anything more unusual than it would be expected to behave. You just can't look at a setup and make up what is taking place so that it fits into your desires and expectations.If Tinman comes here, then the "real world" includes all manner of people that will make suggestions.  Some people are suggesting "negative resistance" which I think is a crazy thing to say..

Negative resistance-->yes,what a crazy thing to say.

Tinman has multiple points of view to consider about his device

Yes,and now i have more to look into.

I decided to do a frequency sweep across the primary coil,as i havnt really been taking much notice as to what was going on there-other than to get my P/in to P/out ratio's. So the blue channel is across a 1ohm CVR,and the yellow channel is across the 1 ohm CVR and primary coil. I decided to put up the math trace as well which is AxB. When the sweep hit around 3.6 megs--well i'll let the scope shot tell the story. The inner secondary has a 100 ohm load across it at this time,but i found it made no difference to the outcome of the wave forms on the primary. Anyway,still looking into this with Smudge -as he gets time,

As i said,i am still looking into this,as it may(probably is) some sort of artifact that i havnt found yet.
The first thing i did to check was to replace the primary coil with a 1.2 ohm resistor(the closest i had to the primaries resting resistance),so as i could make sure there was no kind of inductance with my CVR going on--That scope shot is also below.

Brad
.

[Drak]

I am also up for carrying out test that others might like to see done--but be specific on the parameters.

I'm not sure how much of a test it would be but you could time charging up a cap with a high farad value going through your HTT through a rectifier, then time it from the source bypassing the HTT going through the same rectifier. The timing might be too close to humanly time. Maybe that won't prove anything, just a thought.

Negative resistance-->yes,what a crazy thing to say.

Yeah, so is negative interest rates.

Edit to add:

Yes, the prize is that you get a visit from the MIB.

Crap, I should have waited. Oh well, I'll be ready.

[tinman]

Below is the video i shot tonight of the negative resistor effect !!apparently!!

https://www.youtube.com/watch?v=o5lge0VZfWw