Partnered Output Coils - Free Energy

[John.K1]

Hi Chris, 

" TK, youre an Idiot in all senses of the word!"    

Ok ,Lets test him ... the picture below.

I am just wondering, you said before it works better with the core.  Did you actually meant split core in the middle?

Thanks,

Peace,
PS: TK  take it easy
 

[John.K1]

The Orbo electric motor was a very low efficiency device.  It drove no external load and ran down a big battery.

Mark, I have done some translation of the document , where some guy mathematically proves the higher efficiency of the resonant motor and transformer etc.  I need to find it and I would appreciate if you take a look at it and tell me what you think about it.

Edit1:  Here is the Impulse LC oscilator document. 

[EMJunkie]

Hi Chris, 

" TK, youre an Idiot in all senses of the word!"    

Ok ,Lets test him ... the picture below.

I am just wondering, you said before it works better with the core.  Did you actually meant split core in the middle?

Thanks,

Peace,
PS: TK  take it easy

Hi John,

Results are in, TK is a Mind Control Subject, deliberately controlled to be a Stooge Troll Villainous Juvenile... No other Tests will be necessary to prove these facts...

Yes, my works shows a Core is best. I have had no luck with Air Cores.

A Split Core, yes Sometimes a split is needed, this depends on the Coil Configurations that one uses. The reason for this, simply is, in one configuration, if you Wind and connect the coils on one singular Core, then this results in a dead short of the coils.

A Split, or Gap does allow the Dead short condition to be removed or reduced. See Andrei Melenchenko's work for more verifiable evidence of this.

   Chris

Damn, TK you're a real Moron!!!

[MarkE]

TK, youre an Idiot in all senses of the word!

Idiots like you will forget me, until the next me comes along, then you will forget them, and then the same with the next one... But do you know what, we could have had Free Energy machines running all of our homes over a 100 years ago if Idiots like you wernt around!

Like I have pointed out many times, what I have bought to the table is not new, its old!

What I am trying to share is not mine, its just a rediscovery of others life works!!!

So if you criticise me, and make ridiculous brain dead comments about my work, then you are in-fact also making these same ridiculous brain dead comments about their work also!!! This part obviously makes you a Troll and a Villainous Juvenile Idiot!!!

Electrical Engineers from all around the globe have tested and do not dispute the facts I have provided, but you and the Joke of all human life, MarkE does!

More ad hominem attacks.  More snooze-ville.

Ref: http://www.padrak.com/ine/KOENIG.html

Imagine that, standard coil winding formulas work.  The document simply repeats what any coil winder has known since the late 1800s and has used to scale the voltage for solenoids, DC motors and such since then.

This is part of my work, my work is a carry on of their work.

You're the most FOOLISH Person on the planet after MarkE! Then the other two stooges follow! Can you see TRUST, can you see COMMON SENSE, can you make an educated decision based of verifiable evidence! Can you really be of benefit to anyone that wished to become better for the future? Do you even care about the future?

I am so disheartened that you would be so stupid, deliberately!

And you offer up yet more ad hominem attacks.

[John.K1]

MarkE ,check my previous post with the document attached.