Energy wheel

[vikram_gupta11]

This Idea is based on Magnetic Repulsion and Kinetic force.

According to diagram there will be a  Wheel and a magnet(1) will be attached with this wheel. There will be a balance system(seesaw system) and two magnets(2no.magnet and 3no. magnet) will be attached with this balance system .

when 1 magnet will repel 2 no.magnet then the 2 no.magnet will move upward and due to this movement the 3 no. magnet will come down and will work to repel 1 no. magnet and wheel will start to rotate.
when 1 no. magnet will again repel 2 no.magnet after a rotation then the 3 no. magnet will again work to repel the 1 no.magnet.

In this way the wheel will rotate again and again.The magnetic strength of 1 no. magnet will be high than 2 no. and magnetic strength of 3 no. magnet will be high than 1 no. magnet.

[adam0702]

Energy recovery ventilation (ERV) is the energy recovery process of exchanging the energy contained in normally exhausted building or space air and using it to treat (precondition) the incoming outdoor ventilation air in residential and commercial HVAC systems. During the warmer seasons, the system pre-cools and dehumidifies while humidifying and pre-heating in the cooler seasons.[1] The benefit of using energy recovery is the ability to meet the ASHRAE ventilation & energy standards, while improving indoor air quality and reducing total HVAC equipment capacity.

This technology has not only demonstrated an effective means of reducing energy cost and heating and cooling loads, but has allowed for the scaling down of equipment. Additionally, this system will allow for the indoor environment to maintain a relative humidity of 40% to 50%. This range can be maintained under essentially all conditions. The only energy penalty is the power needed for the blower to overcome the pressure drop in the system