user TURBO?s replication of Steven Mark?s TPU ?

[starcruiser]

Stephan,

If possible adjust the duty cycle down to say 5% or so

[twosox]

@juice

i've installed 'visual analyser' on two machines, the wave gen is stereo, very nice separation too, so two freq's from one machine and the third from another. the program does have a calibration part to it so the junk from the computer can be minimised, but i'll be building a standalone 3 channel generator later. something i did see while tinkering, if i set all the channels to pump out 600hz squarewave into the coils, after 3-4 seconds the top end of the spectrum 10khz-20khz slowly built up and rolled in and out like the waves on a beach, looked good but nothing usefull, i don't think.

Also 'visual analyser' has a time capture, you can set it to capture upto 100 seconds of the scope output, might be useful for some.

derek.

[hartiberlin]

In my unit bifilar setups are not good, just normal wiring will bring induction output..

[hartiberlin]

I have my additional center "feedback coil" wound onto a plastic drinking glas. When I put my 2 hematite shocker magnets in there (see Overunity store) they shake like hell at the right frequency.. Now if I could tune the resonance frequncy of the output coil with a bigger cap exactly to this low toggling vibration  frequency of the magnets, I could generate probably much more power output....
But now first the test with the noise generators...

[dean_mcgowan]

"All his knowledge and training is still in there, it just comes out with completely new associations, in bits and starts like little technical jewels from a future civilization."

f^&*ing brilliant .. god i love this shit !!!

That has to be the best single line i have read in years and I do love my literature.

Your a friggin genius whether you like it or not Holmes