A new "lever" design

[buzneg]

This is simpler then my other design,

http://img519.imageshack.us/img519/4954/model2dv7.png

[buzneg]

Simpler yet.........
http://img503.imageshack.us/img503/8742/model3nh2.png

[FreeEnergy]

how about an animation for your design?

[buzneg]

here's some drawings of it going through it's motion

the red half circle is the magnetic hill and it starts at the top and gets closer to the bar's path, which  has one magnet on each end. It only uses attraction. The small black circle is a rotating shaft.

part1
http://img391.imageshack.us/img391/5282/cycle1kf6.png

part2
http://img151.imageshack.us/img151/1791/cycle2ao1.png

part3
http://img151.imageshack.us/img151/7177/cycle3js6.png

part4
http://img201.imageshack.us/img201/1258/cycle4dn0.png

[buzneg]

It's a standard attraction hill, the magnets get closer and closer to the path of the passing magnet.

To calculate a lever it's force x Distance, so the long side is say 4" and has a force of 2, that equals 8, and the short side is D1" and F5 = 5. So the long end pulls it into the attraction even though it has less force. Most importantly it pulls it out of attraction, where the sticky spot usually is.

I'll do a side view