RANT CAFFE ASYLUM

[EMJunkie]

Another riddle?

To buy time! Pretending that you know?

And you want to help humanity? Open source?

This is not only boring, but disgusting!


You will fall one day, big time.

Whoops, Foot In Mouth Again!

The length of the secondary coil is used to calculate the wire weight. In the past it was thought that the secondary coil wire length should match the quarter wave length of the Tesla coil's resonate frequency. However, it has since been determined that it's unnecessary.

From further investigation by others, notably Dollard[5,10], where the density of the conductor in the primary and secondary is the same, (e.g. for a primary and secondary both with copper as the conductor), equal volumes of the conductors can be considered equivalent to equal weights of the conductors, and has been found to apply best when working at lower frequencies where the skin effect does not have a significant effect on the impedance of the conductor, e.g. when working with normal copper or aluminium conductors at a frequency < 3000kc. At higher frequencies where the skin-effect can dominate the impedance of the conductor, balancing the bounding conditions for the two fields of induction can be better accomplished by equal surface area of the conductors.

I think the people here, that know nothing, could be a bit quieter and try to learn something, what does everyone else think?

Learning something valuable is better than constantly listening to Dumb is it not?

Grow, Evolve, Unite, Share and Love Each Other! Please try!

Best wishes,
   EMJ

[hartiberlin]

Well, I am getting many emails that here is going on only libel and flame wars...
As Chris has its own forum, maybe it would be better, if he will continue with his stuff only on his own forum...
Well...so I will close his thread and link to his own forum...
http://www.aboveunity.com/thread/partnered-output-coils-1/