Lords of the Ring

[innovation_station]

gk i will walk this path as well  i have always liked those coils but have not tested them at all yet built them yes but have not tested them until today i start now!!

i must wind some hemholtz coils but i have only 22ga solid or 18ga lamp wire so i guess i make both with what i have then go from there we will see

i start right now!

william

and i will share all no matter how dumb it seams at the time 

[giantkiller]

gk i will walk this path as well  i have always liked those coils but have not tested them at all yet built them yes but have not tested them until today i start now!!

i must wind some hemholtz coils but i have only 22ga solid or 18ga lamp wire so i guess i make both with what i have then go from there we will see

i start right now!

william

and i will share all no matter how dumb it seams at the time 

Go to Radio shack and get the 26 awg stranded, $5.00us. Use cable ties or velcroe straps. All materials are low heat except the copper for safety. I got the Turbo coil up only half way and produced simliar effects as the GK4 but safer. You have children walk in on you while testing and that is very bad. The coil must auto shutdown first should you drive it correctly and it attains runaway. Just in case. Accidents happen ya know? You might find something in your tests.

The only dumb thing is if the kids get hurt.

--giantkiller.

[innovation_station]

gk i owe to you a great deal too im a guy that owes a lot right now  but i do pay up you all will see  it much sooner than you think

you know i will do as i say if i am not beleaved just let me show you all in time  and i will    right now life is hard and has always been but chioses i have made will change this forever

and i will not hold out or sell out

that my friends is not at all my way


open soursce  for life

ISTEAM!!

those are the decisions i have made and now i will walk the path

[giantkiller]

I added TPU nomenclature to the winding labels.

The whole TPU here is wired clockwise for these tests. I will flip it over next time.
I have one freq input of 115khz.
I have the output of each collector connected to its feedback.
Then each feedback output connected together to the middle collector.
I got the current draw down to 1/8 amp.
The waveform shown has a dissipating ring after each pulse.
This operation does ramp up to produce the tinglies when I am up close to the coil.
You can see the double kick at the start.
But wait, there's more,
The kicks can be felt at 6 inches away and I can feel the small high speed particles hitting my lower arm up to my elbow.

Tomorrow I put in another frequency. I need to phase it into the declining spikes of the first freq pulse.

[AhuraMazda]

@GK

please comment: do you observe any noticeable temperature changes such as heating or cooling ?